Sea Gull Lighting HC-231 Jamestowne 1-Light 11.25-in Black Outdoor Wall Light Instruction Manual
- June 9, 2024
- Sea Gull Lighting
Table of Contents
HC-231 Jamestowne 1-Light 11.25-in Black Outdoor
Wall Light
Instruction Manual
HC-231 Jamestowne 1-Light 11.25-in Black Outdoor Wall Light
Installation And Safety Instructions
HC-231
Line art shown may not exadly match the feature endceed. However the
intallation instructions do apply to the feature.Fill insart Number on carton
and this sheet for Future Perference ITEM#………………………
IMPORTANT SAFETY INSTRUCTIONS
- Be sure the electricity to the system you are waking on is turned off; either the fuse removed ar the circuit treater se/ at oft
- Use of other manufacturers components win void warranty, listing and create a potential safety hazard.
- If you se umlaut as to how to proceed, catact a quarried electrioian
- You don’t need special tools to natal this fixture.
- Be ease to lobo w the steps in the order given.
- Proper wiring is essential for the sale operation of this fixture
- To reduce the risk of line electric shook or personal Injury, moult to ottiet box or supporting system able b support the weigtt of the ratite.
- Read instructions carefully.
- Save these instructions.
WET LOCATION
NOTE: FOR FIXTURES LABELED FOR WET LOCATION AND USED OUTDOORS.
CAUTION: To reduce the risk of electrical shock, provide a watertalnt
seal between the fixttre and the moaltng surface by using a silicone of wit
dar cakang.
NOTE This glass is hindcrafted, the slight knperfecticre in the crag add
to the authentrAty of the fuctue.
Fixtures math photo-eels shotad be moulted at least 48′ forn all sides to
avoid reflection of It back onto Photo-cell, causing the Photo-cell to
malfunction or flicker.
CLEANING
To dean, wipe foctre with a soft cloth. Clean glass with a mid soap.
Do not use abrasive materials such as scaring pads a powders, steel wool a
abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. Pala for this fixture can be ordered from place of purcahese. Be are 10 use exact working from illustration when ordering parts.
BEFORE YOU BEGIN
STEP 1:
Carefullly remove the futue from the carton and cheak that al parts we
included, as shown in Figure 1. Be carefully not to misplace any of the screws
a parts which we needed to instal this fixtue.
STEP 2:
(If Applicable) ‘Thread loop (F) to top of ftxture. Thread supplied #8-32
screw thrcugh scrol (G) and backplate (D). Thread suppled hex nut onto back
plate side of #8-32 screw to secure scroll (G) to backplate (D).
STEP 3:
Place end of scrall (G) into loop (F).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>