Minka Lavery 2737-709 Graham Avenue 4 Light Smoked Iron Wheel Chandelier Instruction Manual
- October 30, 2023
- MINKA LAVERY
Table of Contents
Minka Lavery 2737-709 Graham Avenue 4 Light Smoked Iron Wheel Chandelier Instruction Manual
PREPARATION (Fig.1 &Fig. 3)
-
Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE WITH CHAIN LOOP (Fig.1 &Fig. 3) -
Connect threading nuts (J) at the end of cable into coupling (K) on fixture body.
-
Determine desired hanging height and thread rods (F1, F2 and F3) to all thread (I) on fixture body. Screw loop (H1) onto rod (F1). Carefully pass wires through each rod as you assemble.
-
Attach quick link (G) to loop (H1) and loop (H2) on canopy (D). Carefully feed wire through loop (H1), quick link (G), and loop (H2).
-
Attach mounting plate (A) to junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5″). The side of the mounting plate (A) marked with “GND” and two convex points must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
-
Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1) -
Slide canopy (D) over mounting plate (A) and secure with screws (E).
-
Slide glass shade (M) over socket (L) and secure with metal ring (N).
-
Install (4) four candelabra base bulbs (O) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification — DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
a. Hardware Bag:
- A. Mounting Plate *1
- B. Mounting Screw*2
- D. Canopy *1
- E. Screw*2
- G. Quick Link*1
- H. Loop*2
b. Hardware Bag:
- F1. ROD 12″*1
- F2. ROD 12″*2
- F3. ROD 6″*1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>