Cotogni P5-6NEW Wireless Earbuds User Manual

Cotogni P5-6NEW Wireless Earbuds User Manual

PACKAGE CONTENTS

• ix Charging Case
• lx USB-C Cable
• 1 x User Manual
• 2x Ear Cap
• A Pair of Earbuds
  

Overawe

CHARGING

1.  Charging earbuds
   
   Put earbuds back to charging case and colse Put earbuds back to charging case, the indicators on earbuds flash.

2. Charaina case
   
   Plug in the cable to the charing case port, The blue light will flashing: the digital display on charging case flashes

SWITCH CONTROL

Turn On
Take the earbuds out of the charging case Or press the touch panel on earbud for 6s

Turn Off
Return the earbuds to the charging case and close the lid, Or touch and hold the earbuds touch panel for 6s ( when both earbuds are used, please touch and hold the both earbuds touch panel for 6s to turn them off. It cannot be turned off if you operate on single earbud )

EARBUDS PAIRING

Once the earbuds are taken out from the charging case, they will automatically power on and enter into pairing mode

Once connecting your device successfully first time,earbuds will reconnect your device automatically when you take them out of the charging case again

BEVICE CONNECTING

1. Turn on the Bluetooth on your device
2. Take earbuds out of charging case
3. Select “P5” from the list of available devices
   

Once connecting your device successfully first time, earbuds reconnect your device automatically when you take them out of the charging case again

DEVICE CHANGING

1. Touch and hold the both earbuds for 10s, earbuds will disconnect from previous device
2. Select the “P5” from your new devices bluetooth list

MUSIC

Double tap the L / R earbud

Touch and hold Touch and hold the the L earbud for 2s R earbud for 2s

VOLUME

Triple tap the L earbud
Triple tap the R earbud

CALLS

Answer/Hang
Up Calls Touch and hold
Double tap L/

Reject Calls
Rearbud U/R for 2s

CONTROLS S LED INDICTORS

Earbuds

Charging Case

SPECIFICATIONS

Earbuds

Charging Case

ATTENTION

1.  Take the earbuds out of the charging case before you use it. The earbuds will power on and enter into pairing mode automatically. Return the earbuds back to the charging case after use, they will power off automatically.
2. Once the earbuds has been successfully connected to your device, they will automatically reconnect to your device when you take them out of the charging case next time.
3. Before you want to connect a new device, please turn off the Bluetooth on the current device or as per the DEVICE CHANGING in this manual.
4. When the earbuds are charging, please close the case lid.
5. Keep this products away from liquid or fire. Do not put the earbuds into the charging case when they are wet.
6. When the earbuds can’ t be charged, please check and make sure the connector of the earbuds charging case are clean and dry.
7. If you need to use single earbud, please take one earbud from the charging case and then connect to your device. Also you can return one earbud back to the charging case when you are using both earbuds, keep using the other earbud without extra operation.

FCC WARNING STATEMENT

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy. If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following.

MEASURES

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>