SISTEMA MATRIX A8 Audio Matrix Processor User Guide
- June 11, 2024
- Sistema
Table of Contents
MATRIX System user guide
MATRIX A8 Audio Matrix Processor
-
There have 2 connections mode for user to select:
-daisy chain network mode, for the system with paging function
-star network mode, fot the system without pageing function.
-
if system have more than one MATRIX A8 devices, and connected RPM-200 Paging MIC, please follow the below steps to set up the system.
-Please daisy chain to link the device via RC-Net IN/OUT port. and the first MATRIX A8 device should connect to the secondary porthe DANTE module or connect router via LAN port, and setting the LAN switch to “LAN” side.
-all the DANTE module connect to a router . select daisy chain mode when open the Matrix system Editor software.
-
If system have more than one MATRIX A8 devices, but no page MIC function, please follow the below steps to set the system:
-no need to daisy chain connect the MATRIX A8 via rc-net port,
-just need to connect to LAN port to the secondary port of the DANTE module
-select star network mode when open the editor software.
-
how to routing the signal to dante network?
-Routing the input signal of A8 to DANTE nework, or routing the network audio from network to all inputs with Matrix system Editor software
-
how to routing the signal in dante network?
-Routing the dante network signal with the DANTE Controller
-
how to set up the for paging function?
-Update the DANTE Module firmware with “DANTE16_VER20170103BK32.dnt” firmware file
-open the DANTE CONTROLLER software , then we can see there are total 16 input/16 output channels for each device.
BroadCast Input01-08/ BroadCast output01-08 channels are used for paging signal transmit and received.
-routing the first one device BroadCast output01-08 channels to the second one BroadCast Input01-08,
routing the second one device BroadCast output01-08 channels to the third one BroadCast Input01-08,
—-routing the last one device BroadCast output01-08 channels to the first one BroadCast Input01-08, so that all the MATRIX A8 can share the paging signal , for example:
-
how to add more device?
-drag out the device from the device list to add to the system -
how to change the device ID or delete the one device
-before connect the system, the user need to set up the device ID, The device ID should be same as the ID that the user wantto connect to.
-
After set up, the system would automatically to assign the ID for each device in this system
-the user can see the ID number in LCD screen except RIO-200. The first 2 number of RIO-200 ID is same as the Matrix A8 that it connected to.
if the RIO-200 connect to RD9/10 Port of Matrix A8,the last 2 number should -
for example ,if Matrix A8 ID==0X1000，then RIO-200 ID==0x1050
if the RIO-200 connect to RD11/12 Port of Matrix A8,the last 2 number should 60.for example ,if Matrix A8 ID==0X1000，then RIO-200 ID==0x1060
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>