jONSBO CR-3000 Air Cooling Radiator User Manual
- June 11, 2024
- JONSBO
Table of Contents
jONSBO CR-3000 Air Cooling Radiator
Product Information
The product is a computer processor from AMD with a model number of (1700). The processor has a 1MB cache and uses the AM4 socket. The package includes the processor only.
Product Usage Instructions
- Before installing the processor, ensure that your motherboard is compatible with the AM4 socket and has the latest BIOS version installed.
- Remove the old processor, if applicable, from the motherboard by gently lifting the retention arm and pulling the processor out of the socket.
- Align the notches on the processor with the notches on the socket and gently place the processor into the socket.
- Lower the retention arm to secure the processor in place. The arm should click into place.
- Apply the thermal paste on top of the processor, ensuring that it covers the entire surface of the processor’s heat spreader.
- Attach the CPU cooler to the motherboard, ensuring that it is properly secured and making contact with the thermal paste on top of the processor.
- Connect all necessary power cables to the motherboard and turn on your computer.
- Verify that the processor is recognized by your operating system by checking the system information or device manager.
Part List
Intel LGA 2011 installation
Intel Installation
- Intel LGA1366 / 1200 / 115X / 1700
- Intel LGA1366 / 1200 / 115X / 1700
- Place the set screw in the corresponding hole position of the Intel bracket, and then insert the gasket
- Install the back plate and fastener
- Install the 2011 screw onto the CPU bracket, install the fastener and fix it with nuts
- Apply heat conduction paste on the CPU
- Remove copper bottom protective film
- Place the heat sink on the CPU and fix it on the installation fastener
- Connect the fan lead to the main board according to the figure above
AMD Installation
- Remove the AMD mounting bracket and keep its original backplane
- Installing the backplane
- AMD Befestigung installieren
- Rendering of installation completion
- Apply heat conduction paste on the CPU
- Remove copper bottom protective film
- Place the heat sink on the CPU and fix it on the installation fastener
- Connect the fan lead to the main board according to the figure above
© 2015 ENERMAX TECHNOLOGY CORPORATION. All right reserved. Specifications are subject to change without prior notice. Some trademark may be claimed as the property of others.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>