JONSBO U6 PC User Manual

JONSBO U6 PC

Package Content

Connectors

Parts Diagram

Installation Guide

Remove external cover

1. Release the four scews on the rear panel
2. Hold the handle on the rear panel, pull it to release the chassis from the cover.

Fan and radiator

1. Rear panel for 120mm fans x 1, top cover for 120 mmx 2 0or 140mm x2 fans. Front panel for 120mm x3 or 140mmx 2 fans (Front panel also accommodates 360/280/240 radiators)

Remove external cover

After attaching the I/O shield to the opening in the rear panel, secure the MB with screws in the corresponding position as shown.

Graphics card Installation

1. Remove the PCI cover and PCI brackets
2. Insert the graphics card on MB socket and secure with screw.

PSU installation

1. Remove the PSU bracket, install the bracket on the PSU.
2. Insert the PSU and bracket into the case, secure With screws.

SSD instalation

1. Install the screws and rubber grommets on the SSD
2. Insert the SSD into corresponding slot, push in to secure it.

HDD Installation

1. Remove HDD cage for HDD installation (Mounting points also compatible with SSD on top cover of HDD cage
2. Reinsert the hard disk cage in the corresponding place and secure with a screw
3. Two attachment points are available. When using a 200mm long power supply, the hard drive cage can mount the mounting point near the front panel.

Close the case

1. Place the inner chassis into the guide rail to advance into the main body.
2. Fasten the 4 screws on the rear panel

2017 JONSBO SHENZHEN TECHNOLOGY CO., LTD. All right reserved. Specifications are subject to change without prior notice. Some trademark may be claimed as the property of others.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>