JONSBO N4 Case for 8 Bay DIY NAS Builds Installation Guide

N4 Case for 8 Bay DIY NAS Builds
Installation Guide

Package Content

Connectors

F PANEL

The connector diagram only shows the line sequence relationship. Please refer to the actual product for functions

Parts Diagram

| Parts
---|---
1| Top cover
2| Half height PCI-E card strip
3| PSU Cage
4| Main Chassis
5| Wood veneer
6| Plastic panel
7| Fan
8| FAN Bracket

Installation Guide

1. Remove the case before installing hardware-01Unscrew the 3 screws on the top plate and push the top cover back.

2. Remove the case before installing hardware-02Remove the power supply rack, fan rack and PCI-E card strip.

3. PSU installation1. The power supply is installed on the power rack.
   2. Place the installed power supply into the chassis and lock it with screws.

4. Cable management Before install the motherboard, please refer to illustration to organize the cabels.

5. Motherboard installation ‘The motherboard is placed in the area shown and locked with screws.

6. Motherboard Installation1.Remove the two screws from the rear bracket.
   2. Insert the graphics card into the motherboard card slot and lock it with screws;

7. Fan/top cover installation Plug in the fan power and install the fan bracket and top cover.

8. Open the plastic filter Hold the notch on both sides of the plastic filter and pullet out to take out the filter.

9. Hard drive installation Use the screws and rubber pads to assemble the hard drive. Place the assembled hard drive into the corresponding holes and push it into the card slot.

Dongguan Sibositong Industrial Co., Ltd.
No.5, Xinglong Lu, Sanzhong Village, Qingxi Town, Dongguan City, Guangdong Province, 523651, China
©2023 Dongguan Sibositong Industrial Co., Ltd. All right reserved. Specifications are subject to change without prior notice. Some trademark may be claimed as the property of others.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>