ORCATORCH D530 1300 Lumens Dive Light User Manual
- June 9, 2024
- ORCATORCH
Table of Contents
User Manual
D530 1300
Lumens Dive Light
PRODUCT INTRODUCTION
Orca Torch D530 is a must-have primary dive light for divers. Its 1300 lumens output and 8 degree super focus beam angle provides a concentrated long beam shot. The light uses a titanium alloy side switch that offers 2 lighting modes, the high mode 1300 lumen and the low mode 380 lumen, which allows for easy operation underwater. The LED indicator light located on the switch button also lets you know the battery’s remaining charge.
PRODUCT FEATURES
- Uses CREE LED, max 1300 lumens
- Uses 1*18650 Li-ion rechargeable battery
- 8° super focus beam angle
- Easy operation with side titanium alloy button switch
- Battery indicator
- Safe lock function, prevents mis-operation
- Intelligent Over-Heat protection
- Water pressure resistant construction ,depth rated to 150 meters
- Reverse polarity protection, to protect from improper battery installation
- Over-discharge protection function
- Aircraft-grade high strength aluminum material ov ine natest diamond grade hard-anodized seawater-corrosion-resistance inis
- Alloy aluminum reflector with professional optical analysis
- Two sides coated toughened glass with high water pressure resistance under deep water
TECHNICAL PARAMETERS
| ANSI/NEMA FL1 | High | Low |
|---|---|---|
| Output | 1300 Lumens | 380 Lumens |
| Runtime | 1h25min | 4h30min |
| Intensity | 21164cd | |
| Beam Distance | 291 m (On land) | |
| Impact Resistant | 1 m | |
| Waterproof | under water 150m | |
| Working voltage | 3-8.4 V | |
| Dimension | 142mm(Length) x 25.5mm(Diameter) x 35.5mm(Head) | |
| Net weight | 136g(excluding battery) | |
| Accessories | One USB rechargeable 18650 Li-ion battery, lanyard, 0-rings |
Notice: Stated data has been measured according to the international flashlight test standards ANSI/NEMA FL1 using one Orca Torch 18650 Li-ion battery (3.7V, 3400mah) under laboratory conditions. The parameters are approximate and may vary between flashlights, batteries, and environments.
OPERATION INSTRUCTIONS
- Modes selection: Press side button to change among high, low, off.
- Battery indicator: When the light is turned on, the battery indicator will be on to show the battery level.
-Green: over 70%
-Orange: 30%-70%
-Red: 10%-30%
-Flashing red: less than 10% - Safe lock function: Hold on the side switch for 5 seconds, the light will turn off and turn into a state of safe lock. The side switch will be useless unless unlocking it by a double press.(The light will flicker twice when you lock or unlock the switch, the battery indicator will be green when pressing the side button in lock mode.)
- Intelligent Over-Heat protection: This torch is specially designed for underwater use. When used on land for too long, it might get too hot. But this torch would drop down its output automatically once its temperature reaches 65° to avoid damage to the light due to overheat.
The total runtime will be extended significantly if the light is used discontinuously.
BATTERY REPLACEMENT
- As shown in the figure, insert the battery with the anode side (+) toward the light head.
- Please do not reverse battery to avoid damage to the flashlight and battery.
- Please do not use battery with higher voltage than flashlight working voltage.
- Please do not use battery with damaged surface or deformation to avoid short circuit, explosion, leakage, etc.
USAGE AND MAINTENANCE
- Please clean the surface of the light with fresh water and wipe it dry after use in case of the seawater corrosiveness.
- Do not drop or place the light on sand in case iron sand stick or go into switch section or screw thread.
- Tighten all the connections of the light before going underwater.
- Please take out the batteries after each diving.
- Please don’t disassemble the sealed head, doing so may cause damage to the flashlight and will void the warranty.
- We recommend the use of high quality batteries. If the flashlight will not be used for a long time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
- Please replace the O-rings if they are damaged after prolonged use and regularly lubricate the O-rings with silicon grease so as to not erode the rubber. Doing so will keep the flashlight properly sealed against water.
- Please clean the contacts of your light from time to time, especially when the light flickers or doesn’t light up. There are probably several reasons for a flickering or not working light:
Reason A: The batteries need to be replaced.
Solution: Replace batteries (Please confirm correct installation of + and
-terminals).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the methods above don’t work, please contact the distributors and refer to
the warranty policy.
PRODUCT WARRANTY
We will replace products afflicted with manufacturing defects within 30 days
of purchase and repair a light free of charge within 12 months of purchase if
problems develop under normal use; if repair is required after 12 months from
the date of purchase, we will charge for parts. The total repair fee is
dictated by the cost of the replaced materials.
Please register your Orca Torch products through official website
www.orcatorch.com to get extra 1 year warranty.
Warning
The flashlight is high intensity lighting device and capable of causing eye
damage, please avoid shining the light directly into the eyes.
ORCATORCH TECHNOLOGY LIMITED
Tel:+86-755-33560383 Fax:+86-755-29454989
Email: info@orcatorch.com
www.orcatorch.com
Address: 7F, Building 6, Rundongsheng Industrial Park, Gush,
Xinxiang, Balan, Shenzhen, China (618102)
www.orcatorch.comhttp://www.orcatorch.com/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>