ORCATORCH SD03 Compact and Multifunctional 4 Colour Dive Beacon User Manual

ORCATORCH SD03 Compact and Multifunctional 4 Colour Dive Beacon

PRODUCT INTRODUCTION

The OrcaTorch SD03 is a compact and multifunctional 4-color dive beacon. It can emit light in 4 different colors and has 8 lighting modes: constant light or flashing mode for each color. Both color and light modes can be chosen by rotating the body. The SD03 can be used as an underwater or outdoor signal light, drive backup light, outdoor regular light, etc. Its shell is made of plastic which provides good light penetration. With excellent waterproofness, it will function up to 100m underwater. There is no doubt that the SD03 is one of the best choices for diving or outdoor lighting.

PRODUCT FEATURES

• 4 single colours and 8 modes integrated in one light.
• Compatible with 1AA battery or 114500 battery.
• Non-slip and comfortable silicone ring.
• The tail D-ring can be used more easily with lanyard.
• Practical and convenient mode memory function.
• Plastic transparent shell with enhanced light guide performance.
• Professional waterproof design, depth rated to 100 meters underwater.
• Reverse polarity protection, to protect the light from improper battery installation.
• Aircraft-grade high-strength aluminum AL-6061-T6 used with type III military-grade hard anodization technology.

INSIDE THE BOX

• SD03 x1
• AA battery x1
• Lanyard x1
• User Manual x1

Note: The 14500 battery is not included in the box. If you need the 14500 battery, please buy it yourself.

SPECIFICATIONS

Notice: Stated data has been measured according to the international flashlight test standards ANSI/NEMA FL1 using one OrcaTorch 14500 Li-ion battery (3.7V, 900mAh) or 1*AA battery (1.5V, 1800mAh) under laboratory conditions. The parameters are approximate and may vary between flashlights, batteries and environments.

PRODUCT PICTURE

BATTERY INSTALLATION

The battery assembly direction is shown in the figure.

Note: The supplied AA battery is not rechargeable. If you need a rechargeable lithium 14500 battery, please buy it yourself.

OPERATION INSTRUCTION

• ON/OFF
  Insert the battery and tighten the tail to turn on the SD03.

• Mode Selection
  After the light is switched on, loosen and tighten the tail to switch modes among white, white flash, red, red flash, blue, blue flash, green, and green flash in sequence.

• MEMORY FUNCTION
  The mode will be memorized if it has worked for more than 3S. The light will start from this mode by default when turned on the next time.

USAGE AND MAINTENANCE

• Please clean the surface of the light with fresh water and wipe it dry after use in case of seawater corrosiveness.
• Do not drop or place the light on sand in case iron sand stick or go into switch section or screw thread.
• Tighten all the connections of the light before going underwater.
• Please take out the batteries after each diving.
• Please don’t disassemble the sealed head, doing so may cause damage to the flashlight and will void the warranty.
• We recommend the use of high-quality batteries. lf the flashlight will notbe used for a long time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
• Please replace the O-rings if they are damaged after prolonged use and regularly lubricate the O-rings so as to not erode the rubber. Doing so will keep the flashlight properly sealed against water.
• Please clean the contacts of your light from time to time, especially when the light flickers or doesn’t light up. There are probably several reasons for a flickering or not working light:

Reason A: The batteries need to be replaced. Solution: Replace batteries (Please confirm correct installation of + and -terminals).
Reason B: The threads,PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol-soaked cotton swab. lf the methods above don’t work, please contact the distributors and refer to the warranty policy.

USAGE AND MAINTENANCE

We will replace products afflicted with manufacturing defects within 30 days of purchase and repair a light free of charge within 12 months of purchase if problems develop under normal use; if repair is required after 12 months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the replaced materials.
Please register your OrcaTorch products through official website www.orcatorch.com to get extra 1-year warranty.

warning
The flashlight is high intensity lighting device and capable of causingeye damage, please avoid shining the light directly into the eyes.

ORCATORCH TECHNOLOGY LIMITED
Tel: +86-755-33560383
Fax: +86-755-29454989
Email: info@orcatorch.com
www.orcatorch.com
Address: 7F, Building 6, Rundongsheng Industrial Park, Gushu, Xixiang, Baoan, Shenzhen, China (518102)

www.orcatorch.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>