ORCATORCH D530 Primary Dive Light for Divers User Manual

D530 Primary Dive Light​ for Divers
User Manual

D530 Primary Dive Light​ for Divers

• D530 Cold White
• D530 Neutral White
• D530 Red
• D530 Blue
• D530 UV
• D530 Green

PRODUCT INTRODUCTION

OrcaTorch D530 is a must-have primary dive light for divers.It offers 6 different color options, Cold white, Neutral white, Red, Blue, UV and Green. The light uses a titanium alloy side switch that offers 2 lighting modes, which allows for easy operation underwater. The LED indicator light located on the switch button also lets you know the battery’s remaining charge.

PRODUCT FEATURES

• Use 1*18650 Li-ion rechargeable battery
• White light beam angle 8° ， Red, Blue, UV, Green beam angle 6°
• Cold white with max 1300 lumens for primary dive light
• Red light offers two light modes for night dives to shoot shy animals
• Blue light works with the yellow filter for marine fluorescence dives and research
• UV 395 light works directly for fluorescent night diving
• Easy operation with side titanium alloy button switch
• Battery indicator
• Safe lock function, prevents mis-operation
• Intelligent Over-Heat protection and Over-discharge protection function
• Water pressure resistant construction ,depth rated to 150 meters
• Reverse polarity protection, to protect from improper battery installation
• Constructed from high-strength A6061-T6 aluminum
• Mil-Spec Type III hard anodized finish for durability and corrosion resistance
• Two sides coated toughened glass with high water pressure resistance under deep water

TECHNICAL PARAMETERS

micro USB cable, lanyard, 0-rings

Notice: Stated data has been measured according to the international flashlight teststandards ANSI/NEMA FL1 using one OrcaTorch 18650 Li-ion battery (3.7V,3400mah) under laboratory conditions. The parameters are approximate and mayvary between flashlights, batteries, and environments.

OPERATION INSTRUCTIONS

1. Modes Selection
   Press side button to change among high, low, off.

2. Battery indicator: When the light is turned on, the battery indicator will be on to show the battery level.
   -Green: over 70%
   -Orange: 30%-70%
   -Red: 10%-30%
   -Flashing red: less than 10%

3. Safe lock function:
   Hold on the side switch for 5 seconds,the light will turn off and turn into a state of safe lock.The side switch will be useless unless unlocking it by a double press.
   (The light will flicker twice when you lock or unlock the switch,the battery indicator will be green when at state of locked.)

4. Intelligent Over-Heat protection:
   This torch is specially designed for underwater use. When used on land for too long, it might get too hot. But this torch would drop down its output automatically once its temperature reaches 65°to avoid damage to the light due to overheat.

5. The total runtime will be extended significantly if the light is used discontinuously.

BATTERY REPLACEMENT

1. As shown in the figure, insert the battery with the anode side (+) toward the light head.
2. Please do not reverse battery to avoid damage to the flashlight and battery.
3. Please do not use battery with higher voltage than flashlight working voltage.
4. Please do not use battery with damaged surface or deformation to avoid short circuit, explosion, leakage, etc.

USAGE AND MAINTENANCE

• Please clean the surface of the light with fresh water and wipe it dry after use in case of the seawater corrosiveness.
• Do not drop or place the light on sand in case iron sand stick or go into switch section or screw thread.
• Tighten all the connections of the light before going underwater.
• Please take out the batteries after each diving.
• Please don’t disassemble the sealed head, doing so may cause damage to the flashlight and will void the warranty.
• We recommend the use of high quality batteries. If the flashlight will not be used for a long time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
• Please replace the O-rings if they are damaged after prolonged use and regularly lubricate the o-rings with silicon grease so as to not erode the rubber. Doing so will keep the flashlight properly sealed against water.
• Please clean the contacts of your light from time to time, especially when the light flickers or doesn’t light up. There are probably several reasons for a flickering or not working light:
  Reason A: The batteries need to be replaced.
  Solution: Replace batteries (Please confirm correct installation of + and – terminals).
  Reason B: The threads, PCB board contact or other contacts are dirty.
  Solution: Clean the contact points with an alcohol soaked cotton swab.

If the methods above don’t work, please contact the distributors and refer to the warranty policy.

PRODUCT WARRANTY

We will replace products afflicted with manufacturing defects within 30 days of purchase and repair a light free of charge within 12 months of purchase if problems develop under normal use; if repair is required after 12 months from the date of purchase, we will charge for parts. The total repair fee is dictated by the cost of the replaced materials.
Please register your OrcaTorch products through official website www.orcatorch.com to get extra 1 year warranty.
Warning
The flashlight is high intensity lighting device and capable of causing eye damage, please avoid shining the light directly into the eyes.
ORCATORCH TECHNOLOGY LIMITED

Tel:+86-755-33560383
Fax:+86-755-29454989
Email: info@orcatorch.com
www.orcatorch.com
Address: 7F, Building 6, Rundongsheng Industrial Park,Gushu, Xixiang, Baoan, Shenzhen, China (518102) ** **www.orcatorch.com

Documents / Resources

| ORCATORCH D530 Primary Dive Light​ for Divers [pdf] User Manual
D530 Primary Dive Light for Divers, D530, Primary Dive Light for Divers, Dive Light for Divers, Light for Divers, Divers
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>