ORCATORCH D520 Palm Sized Dive Light User Manual
- June 1, 2024
- ORCATORCH
Table of Contents
ORCATORCH D520 Palm Sized Dive Light
Product Information
Specifications
-
Output: 1000 lumens
-
Runtime: 2 hours
-
Beam Distance: 220 meters (on land)
-
Intensity: 12000cd 1m
-
Impact Resistant
-
Waterproof
-
Working Voltage: Not specified
-
Dimension: 134.5mm (Length) x 24mm (Diameter)
x 30mm (Head) -
Net Weight: 129g excluding battery
-
Accessories: 18650 3400mAh USB Type-C
Rechargeable Battery x 1, USB Type-C Charging Cable x 1, Lanyard x
1, Spare O-ring x 3
Product Usage Instructions
Operation Instructions
- ON/OFF: Insert the battery and tighten the light head to turn on the flashlight, unscrew the light head to turn it off.
- Underwater Use: Tighten the light head before going underwater and do not unscrew it until out of water to avoid leaking.
- Runtime: Total runtime will be extended if the light is used discontinuously.
Battery Replacement
- Insert the battery with the anode side (+) towards the light head.
- Avoid reversing the battery to prevent damage to the flashlight and battery.
- Do not use a battery with a higher voltage than the flashlight’s working voltage.
- Avoid using a battery with a damaged surface or deformation to prevent short circuits, explosions, leakage, etc.
Usage and Maintenance
If facing issues like battery replacement or dirty contacts, follow the
solutions provided in the manual. Contact distributors if problems persist.
Product Warranty
We offer warranty services for manufacturing defects within 30 days of
purchase. Free repair is provided within 12 months of purchase under normal
use conditions. After 12 months, parts replacement may incur charges. Register
products on our website for an additional 1-year warranty.
Warning
Avoid shining the light directly into the eyes as it can cause eye damage.
Contact Information
ORCATORCH TECHNOLOGY LIMITED
- Tel : +86-755-33560383
- Fax : +86-755-29454989
- Email : info@orcatorch.com
- Address : 4th Floor, Building 6, Huafeng Science and Technology
- Park, 535 Fengtang Avenue, Fuyong, Bao’an District, Shenzhen, China (518103)
- Website : www.orcatorch.com
Frequently Asked Questions (FAQ)
-
Q: How do I replace the battery?
A: Insert the battery with the anode side facing towards the light head to replace it. -
Q: What should I do if the flashlight stops working?
A: Check for dirty contacts or try replacing the batteries following the manual instructions. If issues persist, contact distributors for assistance.
PRODUCT INTRODUCTION
ORCATORCH D520 is a palm-sized diving light with a mechanically rotary switch. The rotary switch offers high reliability underwater. Using the USA CREE neutral white LED, its max output can reach 1000 lumens, meanwhile the 5000K LED color temperature provides superb color rendition. Powered by one 18650 battery, its max runtime can reach 2 hours. Plus robust water pressure resistant construction, high portability and easy operation, D520 would be qualified for both recreational diving as a primary light and deep diving as a backup light.
PRODUCT FEATURES
- Cree LED, max 1000 lumens output
- Uses 118650/2CR123A/2*16340 battery
- Mechanically head rotary switch offers high reliability underwater
- Water pressure resistant construction , depth rated to 150 meters
- Reverse polarity protection, to protect from improper battery installation
- Over-discharge protection function
- Aircraft-grade high strength aluminum material
- The latest diamond grade hard-anodized seawater-corrosion-resistance finish
- Alloy aluminum reflector with professional optical analysis
- Two sides coated toughened glass with high water pressure resistance under deep water
TECHNICAL PARAMETERS
| ANSI/NEMA FL1 | Mode |
|---|---|
| Output | 1000 lumens |
| Runtime | 2h |
| Beam Distance | 220m (On land) |
| Intensity | 12000cd |
| Impact Resistant | 1m |
| Waterproof | under water 150m |
| Working voltage | 3 – 8.4 V |
| Dimension | 134.5mm(Length) x 24mm(Diameter) x 30mm(Head) |
| Net weight | 129g excluding battery |
| Accessories | 18650 3400mAh USB Type-C Rechargeable Battery x 1 USB |
Type-C Charging Cable x 1, Lanyard x 1, Spare O-ring x
Notice: Stated data has been measured according to the international flashlight test standards ANSI/NEMA FL1 using one OrcaTorch 18650 Li-ion battery (3.7V, 3400mah) under laboratory conditions. The parameters are approximate and may vary between flashlights, batteries, and environments.
OPERATION INSTRUCTIONS
- ON/OFF: Insert the battery and tighten the light head to turn on the flashlight, unscrew the light head to turn it off.
- Please tighten the light head to turn on the light before you go underwater, and do not unscrew the light head until you have gone out of water to avoid leaking underwater.
- The total runtime will be extended significantly if the light is used discontinuously.
BATTERY REPLACEMENT
- As shown in the figure, insert the battery with the anode side (+) toward the light head.
- Please do not reverse battery to avoid damage to the flashlight and battery.
- Please do not use battery with higher voltage than flashlight working voltage.
- Please do not use battery with damaged surface or deformation to avoid short circuit, explosion, leakage, etc.
USAGE AND MAINTENANCE
- Please clean the surface of the light with fresh water and wipe it dry after use in case of the seawater corrosiveness.
- Do not drop or place the light on sand in case iron sand stick or go into switch section or screw thread.
- Tighten all the connections of the light before going underwater.
- Please take out the batteries after each diving.
- Please don’t disassemble the sealed head, doing so may cause damage to
- the flashlight and will void the warranty.
- We recommend the use of high quality batteries. If the flashlight will not be used for a long time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
- Please replace the O-rings if they are damaged after prolonged use and regularly lubricate the o-rings so as to not erode the rubber. Doing so will keep the flashlight properly sealed against water.
- Please clean the contacts of your light from time to time, especially when the light flickers or doesn’t light up. There are probably several reasons for a flickering or not working light:
- Reason A : The batteries need to be replaced.
- Solution: Replace batteries (Please confirm correct installation of + and – terminals).
- Reason B : The threads, PCB board contact or other contacts are dirty.
- Solution : Clean the contact points with an alcohol soaked cotton swab. If the methods above don’t work, please contact the distributors and refer to the warranty policy.
PRODUCT WARRANTY
We will replace products afflicted with manufacturing defects within 30 days
of purchase and repair a light free of charge within 12 months of purchase if
problems develop under normal use; if repair is required after 12 months from
the date of purchase, we will charge for parts. The total repair fee is
dictated by the cost of the replaced materials.
Please register your OrcaTorch products through official website
www.orcatorch.com to get extra 1 year warranty.
Warning
The flashlight is high intensity lighting device and capable of causing eye
damage, please avoid shining the light directly into the eyes.
ORCATORCH TECHNOLOGY LIMITED
- Tel :+86-755-33560383
- Email : info@orcatorch.com
- Fax :+86-755-29454989
- www.orcatorch.com
- Address : 4th Floor, Building 6, Huafeng Science and Technology Park, 535 Fengtang Avenue, Fuyong, Bao’an District, Shenzhen, China (518103)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>