ORCATORCH D570 2 In 1 Laser Dive Light User Manual
- June 1, 2024
- ORCATORCH
Table of Contents
ORCATORCH D570 2 In 1 Laser Dive Light
Product Information
Specifications
- Product Name: OrcaTorch Flashlight
- Warranty: 12 months for free repairs under normal use conditions; charges apply after 12 months
- Extra Warranty: Register on www.orcatorch.com for an additional 1-year warranty
- Warning: Avoid shining the light directly into the eyes to prevent eye damage
Product Usage Instructions
Operation Instructions
- Ensure the flashlight is fully charged or has fresh batteries inserted.
- To turn on the flashlight, press the power button located on the body of the device.
- Adjust the light intensity by toggling the settings according to your preference.
- To turn off the flashlight, press the power button again.
Usage and Maintenance
- Use the flashlight only for its intended purpose and avoid shining it directly into the eyes.
- Clean the flashlight regularly with a soft, dry cloth to remove any dirt or debris.
- Store the flashlight in a cool, dry place when not in use to prolong its lifespan.
Frequently Asked Questions (FAQ)
-
Q: What should I do if my OrcaTorch product develops a problem?
A: If your product has a manufacturing defect within 30 days, we will replace it for free. For issues after 30 days, visit our official website for repair options. -
Q: How can I claim the extra 1-year warranty?
A: Register your OrcaTorch product on www.orcatorch.com to avail of the additional 1-year warranty.
PRODUCT INTRODUCTION
OrcaTorch D570 is a 1500 lumens dive light specially designed for recreational diving and commercial diving. Besides regular white beam, it offers quick access to the laser light. The two light sources can be controlled independently which meet your different usage scenes. The side switch with battery indicator offers easy operation and also instant knowledge of remainina battery level.
PRODUCT FEATURES
- Two light sources :8 white beam + laser light
- Easy operation with side button switch
- Battery indicator
- Intelligent Over-Heat protection Water pressure resistant construction ,depth rated to 150 meters
- Reverse polarity protection, to protect from improper battery installation
- Over-discharge protection function v Aircraft-grade high strength aluminum material
- The latest diamond grade hard-anodized seawater-corrosion-resistance finish
- Two sides coated toughened glass with high water pressure resistance under deep water
TECHNICAL PARAMETERS
Notice: Stated data has been measured according to the international
flashlight test standards ANSI/NEMA FL1 using one OrcaTorch 18650 Li-ion
battery (3.7V, 3400mah) under laboratory conditions. The parameters are
approximate and may vary between flashlights, batteries, and environments.
OPERATION INSTRUCTIONS
- Modes selection: Press side switch to turn on the laser light, release to turn it off. Double click the side switch to turn on the white light, double click again to turn it off.
- The two light sources can be controlled independently.
- Battery indicator: When the white mode is turned on, the battery indicator will be on to show the battery level.
- Green: over 70%
- Orange: 30%-70%
- Red: 10%-30%
- Flashing red: less than 10%
- Intelligent Over-Heat protection: This torch is specially designed for underwater use. When used on land for too long, it might get too hot. But this torch would drop down its output automatically once its temperature reaches 65 to avoid damage to the light due to overheat.
- The total runtime will be extended significantly if the light is used discontinuously.
BATTERY REPLACEMENT
- As shown in the figure, insert the battery with the anode side (+) toward the light head.
- Please do not reverse battery to avoid damage to the flashlight and battery.
- Please do not use battery with higher voltage than flashlight working voltage.
- Please do not use battery with damaged surface or deformation to avoid short circuit, explosion, leakage, etc.
USAGE AND MAINTENANCE
Please clean the surface of the light with fresh water and wipe it dry after use in case of the seawater corrosiveness.
- Do not drop or place the light on sand in case iron sand stick or go into switch section or screw thread.
- Tighten all the connections of the light before going underwater. Please take out the batteries after each diving.
- Please don’t disassemble the sealed head, doing so may cause damage to the flashlight and will void the warranty.
- We recommend the use of high quality batteries. If the flashlight will not be used for a long time, remove the batteries to avoid damage from electrolyte leakage or battery explosion.
- Please replace the O-rings if they are damaged after prolonged use and regularly lubricate the o-rings with silicon grease so as to not erode the rubber. Doing so will keep the flashlight properly sealed against water. Please clean the contacts of your light from time to time, especially when the light flickers or doesn’t light up. There are probably several reasons for a flickering or not working light:
- Reason A : The batteries need to be replaced.
- Solution: Replace batteries (Please confirm correct installation of + and – terminals).
- Reason B : The threads, PCB board contact or other contacts are dirty.
- Solution: Clean the contact points with an alcohol soaked cotton swab.
If the methods above don’t work, please contact the distributors and refer to the warranty policy.
PRODUCT WARRANTY
We will replace products afflicted with manufacturing defects within 30 days
of purchase and repair a light free of charge within 12 months of purchase if
problems develop under normal use; if repair is required after 12 months from
the date of purchase, we will charge for parts. The total repair fee is
dictated by the cost of the replaced materials.
Please register your OrcaTorch products through official website
www.orcatorch.com to get extra 1 year warranty.
Warning
The flashlight is high intensity lighting device and capable of causing eye
damage, please avoid shining the light directly into the eyes.
ORCATORCH TECHNOLOGY LIMITED
- Tel :+86-755-33560383
- Fax :+86-755-29454989
- Email : info@orcatorch.com
- www.orcatorch.com
- Address : 4th Floor, Building 6, Huafeng Science and Technology Park, 535 Fengtang Avenue, Fuyong, Bao’an District, Shenzhen, China (518103)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>