WILDFIRE Ranch Pro 30 Inch Propane Griddle User Guide
- June 27, 2024
- WILDFIRE
Table of Contents
WILDFIRE Ranch Pro 30 Inch Propane Griddle
TOOLS
You will also need the following tools
- Phillips head screwdriver
- 1/ 4″ socket
- Phillips head right angle ratchet ( optional}
- Adjustable wrench
Parts Kit
USING AND INSTALLATION INSTRUCTION
Your conversion kit will arrive with all the parts needed to convert your
natural gas griddle to liquid propane or natural gas (Fig 1.1 ). Included gas
specific regulator natural gas or liquid propane conversion orifices infrared
conversion orifice
The conversion kit is made to work across Wildfire’s entire collection, for
this application, we will need two of the conversion orifices (Fig 1.2) and
the gas-specific regulator.
Start by removing both the rear wind guard and front drip tray to gain access
to the griddle plate mounting brackets shown in Figures 2.1 & 2.2.
With both removed you will now have access to remove the griddle by
unscrewing the three (Phillips} mounting screws shown in Figure 2.3. The front
two screws may be hard to access without the use of a right-angle ratcheting
screwdriver.
Once all three mounting screws are removed,
the griddle surface may be taken off by lifting it straight up. Use caution as
the griddle surface is heavy.
Once the griddle surface is removed you will have access to the burners, removing the single screw holding each burner at the back of the griddle will allow you to gently pull the burner free.
- IMPORTANT! Use caution when pulling the burner free, as it will still be connected by the thermopile circled in Figure 3.1 there is enough slack to allow the burner to be moved to the side but not be fully removed from the griddle body.
- With the burner moved to the side, you will have access to the gas orifice through the burner mounting hole circled in Figure 3.2.
- Using a 1/ 4″ socket the original gas orifices can be unscrewed and removed through the burner hole.
Repeat this entire process on both burners.
- After removing the old gas orifice, the new orifice provided (Fig 1.2) in the conversion kit can be installed by carefully using the socket to hold the orifice and screwing it in.
- Repeat this process on both burners.
- You can now work back through the steps to reattach the griddle surface.
- With everything reassembled remove the original hose and regulator at the rear of the griddle and install the provided appropriate hose and regulator from the conversion kit. Shown in figures 4.3 & 4.4.
CONGRATULATIONS, your Wildfire Ranch Pro Griddle has now been fully converted to the gas type of your choice.
-
602.344-4840 • wildfireoutdoorliving.com
customerservice@wildfireoutdoorliving.com -
Copyright© 2024 RPG Brands (Wildfire Outdoor Living}. All rights reserved.
-
Products and specifications are subject to change without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>