OKIN RF408B Remote Control Instructions

: June 10, 2024
: OKIN

Table of Contents

Item
FCC Statement:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Issue Department: Bedding Division
System Instruction
Instruction of RF408B
Date: 2022-11-18
Edition: 1.1

Figure 1 button ofremote

Item

PLAY /PAUSE button 1
Press the PLAY /PAUSE button to play or pause the audio device.
Sync button 2
Press Sync button to active the model of the audio device, between Sync and Async model.
Timer 3
Press the Timer button to set the active time of the audio device.
Volume + 4
Press the volume + button to increace the volume of the audio device.
Volume – 5
Press the volume – button to decreace the volume of the audio device.
Power 6
Press the power button to open and shut the light.
Morning 7
Press the morning button to set the light into morning model.
Evening 8
Press the morning button to set the light into Evening model.
Brightness + 9
Press the volume + button to increace the brightness of the light.
Brightness – 10
Press the volume – button to decreace the brightness of the light.
Timer 11
Press the Timer button to set the active time of the light.

FCC Statement:

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement：
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated without restriction.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

ISED Statement:
This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B).

Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated without restriction.