EXTOL 3915 Hand Mitre Saw User Manual
- June 9, 2024
- EXTOL
Table of Contents
EXTOL 3915 Hand Mitre Saw User Manual
FIGURE OF THE ASSEMBLED SAW, SPECIFICATIONS OF THE SAW STRIP, WIDTH AND HEIGHT OF THE CUT
ANGLES IN N-GONS
TECHNICAL DETAILED DRAWING
Use
For work with wood, for quadrangle, pentagon, hexagon and octagon frames, letterboxes, small libraries, window and door frames, floor strips, aluminium, steel and plastic profiles. Cutting height is 115 mm and width is 110 mm.
Technical details
-
Cutting frame : rigid frame with an adjustable cutting angle with a metal scale.
It is possible to use a few basic limit stops to set the various angles. -
Material of base board: wood
-
Tensioning : it is recommended to use standard saw strip tension; the saw is supplied with a universal saw strip for wood and plastic, length: 550 mm.
Replacement saw strips are available – two types exist on the market:
a) for wood and plastic
b) light metals – Cu, Zn, Al, Ni -
Setting a coarser cut : it is possible to set a coarser cut using the rings (15).
-
Guiding the saw : the saw is guided using four rigid riders, which ensures precision cuts.
To cut the required angle, it is necessary to set the angle that expresses the remainder to 90°. For example, to cut an angle of 36°, it is necessary to set 54° on the scale (90°-36° = 54°).
Assembly
- Insert bolt (7) into the hole (17) in the guide frame (5), and then into hole (6) in the cutting table (1) and secure it in place using nut (8).
- Screw the plastic indicator using bolt (18) on the guide frame (5) as shown in the figure.
- Using four bolts (18), mount the table (1) on to the wooden base of the cutter (9).
- Slide the plastic riders (14) together with the saw (20) on to the guide rods (12) and secure them in place using rings (15).
- Screw the short clamping rods (11) with the clamping bolt (21) to the frontal part of the cutting table (1) and the long clamping rods (10) from the side.
ATTENTION
- The saw strip heats up during the cutting process and may be hot. Danger of burns. Prior to replacing the saw strip, allow it to cool down.
Meaning of markings on the label – safety instructions
Warranty terms and conditions
- This product is covered for a warranty period (responsibility for defects) as set by to law. If requested by the buyer, the seller is obliged to inform him about his rights relating to faulty performance (warranty terms and conditions) in written form. The warranty does not cover wear and tear or damage to the saw strip resulting from standard or incorrect use since this is not a manufacturing defect.
CONTACT DETAILS
Manufacturer : Madal Bal a. s.
Průmyslová zóna Příluky 244, 76001 Zlín, Czech Republic.
extol.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>