ZALMAN Z-Sync A-RGB Controller User Manual
- June 9, 2024
- ZALMAN
Table of Contents
ZALMAN Z-Sync A-RGB Controller
- To ensure safe and easy installation, please read the following precaution.
- Product design and specifications may be revised to improve quality and performance without notice.
Precautions
- Read this manual carefully before installing.
- Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
- Wear gloves to prevent accidents when installing the product.
- Severe damage may occur when mounting the system, so do not apply excessive force.
- Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
- Be careful not to block the ventilation hole of the product when using the system.
- Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
- Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
- Do not insert your hand or another object into the product during operation, as this may injure your hand or damage the object.
- Store and use the product out of children’s reach.
- Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
- The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.
Cable Connection
- Connect USB Header Pin of USB 2.0 Cable(Mini USB 5-Pin to USB 2.0 Header Pin) to Motherboard USB Header.
- Connect SATA Connector from Z-SYNC controller to Power supply SATA Output.
- Connect 3-Pin(Addressable) connector from LED to Z-SYNC.
- Turn on the System.
- Install Exclusive software for Z-Sync.
Caution
- Please check the connector before plug in.
Caution
- Please check the connector before plug in.
- Connecting 4-Pin(PWM) or 3-Pin connector(not addressable) to Z-SYNC may cause the malfunction
- Exclusive Z-Sync software can be download from www.zalman.com
- Please refer software manual in the installation program for the software settings.
Cable Specifications
Specifications
- Model: Z-SYNC
- Dimensions: 79(D) x 49(W) x 12(H)mm
- Weight: 48g
- LED Color: RGB
- Operating voltage: 5V
- RGB Channel: 8CH
- RGB Rated voltage: 5V
- RGB Rated current: 4A (Total)
- Components: Z-SYNC x 1, Triple Fan Cable x 1, Mini USB 5pin to USB 2.0 Pin Header x 1
Dimensions
Certification
Accessories
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>