ZALMAN Z3 Series ATX Mid Tower PC Case User Manual

ZALMAN Z3 Series ATX Mid Tower PC Case

Cautionary Note

1. Please read this manual thoroughly prior to installation.
2. Before installing, check the components and condition of the product, and if any problem is found, contact the retailer.
3. Please wear gloves while handling this product to prevent injuries.
4. Incorrect cable connections may cause short circuits leading to fire hazards.
5. Do not block the front intake vent or the rear exhaust vent.
6. Keep this unit away from heat sources, direct sunlight, water, oil and place the unit on a flat and well-ventilated area.
7. Do not clean the product surface with chemicals or wet cloth. (chemicals: industrial alcohol, pait thinner and organic solvent etc.)
8. Avoid inserting objects or hands into the system while it is in operation to prevent product damage and injuries.
9. Zelman Tech Co., Ltd. is not responsible for any improper use.
10. Product design and specifications may be revised to improve quality and performance.

Components

Components

• *A Bolt (#6-325mm) x 13 [PSU,PCI]**

• *B Bolt (M35mm) x 25 [M/B,FDD,SSD,ODD]**

• *C Bolt (FAN) x 4 (BH M328mm)
  **

• *D Bolt (FAN) x 2 (FH Tap510mm)
  **

• *E Bolt (M35mm) x 4
  **

• Stand Off x 6
  

• Cable Tie x 5
  

• HDD Guide
  

• **Manual x 1

**

Z3 Plus Components

• VGA Guide x 1
  
  

• **Guide Clip x 2

**

Front I/O Ports

#

| Part
---|---
①|

FAN Controller

②

| Power Button
③|

HDD LED

④

| Reset Button
⑤|

Headphones

⑥

| Mic
⑦|

USB 2.0

⑧

|

USB 3.0

Installation

Side Panel Removal

Motherboard Installation

There are 6 Stand-offs preinstalled. Please refer to the diagrams below for additional Stand Off positions (based on motherboard type).

VGA Card Installation

|

A Bolt

---|---

① Unfasten the Hand Screw holding the PCI Cover and disassemble the cover.
② Remove the PCI Slot Cover.
③ Install the VGA Card and fasten with a fixing screw.

Tip

1. The VGA Support system is designed to support the weight of high profile vedio cards to prevent warping.
   – Assemble the clip and the nut as shown

– Install the Fan on the assemble clip as shown

5.25″ and 3.5″ Drive Installation

1. Front Cover removal
   

2. ODD Installation
   

3. 3.5 Installation
   

3.5″ HDD Installation

• Use the HDD Guide to install 3.5″ HDD.
  

• When transporting an assembled system, please secure the HDD with Bolt E as shown above.
  |

E Bolt

---|---

Cable Connection

I/O Port

2.5″ HDD and SSD Optional

• 2.5″ HDD and SSDs can be installed on the right side of case as shown in the diagram below.
  |

B Bolt

---|---

References

• ANDPRO.RU - интернет магазин компьютерной и офисной техники с выгодными ценами и доставкой

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>