ZALMAN M2 Mini-ITX Computer Case – Gray User Manual
- June 3, 2024
- ZALMAN
Table of Contents
ZALMAN M2 Mini-ITX Computer Case - Gray User Manual
Precautions
■ Read this manual carefully before installing.
■ Check the product and components before installing. If you find any
abnormality, contact the location where you purchased the product for a
replacement or refund.
■ Wear gloves to prevent accidents when installing the product.
■ Severe damage may occur when mounting the system, so do not apply excessive
force.
■ Connecting the cable incorrectly may cause a fire due to a short circuit.
Make sure to refer to the manual when connecting the cable.
■ Be careful not to block the ventilation hole of the product when using the
system.
■ Avoid locations with direct sunlight, water, moisture, oil, and excessive
dust. Store and use the product in a well-ventilated location.
■ Do not wipe the surface of the product using chemicals. (organic solvents
such as alcohol or acetone)
■ Do not insert your hand or other object into the product during operation,
as this may injure your hand or damage the object.
■ Store and use the product out of children’s reach.
■ Our company assumes no responsibility for any problem that occurs due to the
use of the product for purposes other than its designated purposes and/or the
carelessness of the consumer.
■ The exterior design and specifications of the product are subject to change
without prior notice to consumers for quality improvement.
1. Specifications
Accessories
I/O Ports
1-1. Removing the side panel
1-2. Riser Cable Installation
2. How to install Guide
3. PSU Installation
- Take out PSU bracket and install PSU as shown in the picture.
- Put PSU bracket with PSU installed back on its designated space shown in the picture.
4. VGA Card Installation
- Take out PCI slot protection cover and install VGA Card as shown in the picture.
5. 2.5″ HDD/SSD Installation
Unscrew thumbscrews and pull out HDD/SSD bracket backwards as shown in the picture
6. Rubber pad Installation
*According to users environment, user can decide to put rubber pad on either bottom side or side panel.
7. Fans Included / Specifications
8. Cable Connection
[Precautions] *See your motherboard’s manual for front panel header locations and pin-outs.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>