ZALMAN T7 ATX Mid Tower Computer Case User Manual

: June 2, 2024
: ZALMAN

Table of Contents

ZALMAN T7 ATX Mid Tower Computer Case
Precautions
Specifications
Dimensions
Accessories
I/O Ports
| Part| #| Part| #| Part| #| Part
Removing the side panels
Documents / Resources

ZALMAN T7 ATX Mid Tower Computer Case

ZALMAN-T7-ATX-Mid-Tower-Computer-Case-product

Precautions

Read this manual carefully before installing.
Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
Wear gloves to prevent accidents when installing the product.
Severe damage may occur when mounting the system, so do not apply excessive force.
Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
Be careful not to block the ventilation hole of the product when using the system.
Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
Do not insert your hand or other object into the product during operation, as this may injure your hand or damage the object.
Store and use the product out of children’s reach.
Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.

Specifications

Model	T7
Case Form Factor	ATX Mid-Tower
Dimensions	384(D) x 202(W) x 438(H)mm
Weight	3.2kg
Case Materials	Plastic, Steel, Acrylic
Motherboard Support	ATX / mATX / Mini-ITX
Maximum VGA Length	305mm
Maximum CPU Cooler Height	160mm
Maximum PSU Length	150mm
PCI Expansion Slots	7
Drive Bays	2 x Combo(3.5” or 2.5”), 4 x 2.5”
Fan Support	Top
Front	3 x 120mm
Rear	1 x 120mm
Bottom	2 x 120mm
Pre-Installed Fan(s)	Front
Rear	1 x 120mm
I/O Ports	1 x Headphone, 1 x Mic, 2 x USB 2.0, 1 x USB 3.0,

Reset Button, Power Button

Dimensions

ZALMAN-T7-ATX-Mid-Tower-Computer-Case-
fig-1

Accessories

ZALMAN-T7-ATX-Mid-Tower-Computer-Case-
fig-2

I/O Ports

ZALMAN-T7-ATX-Mid-Tower-Computer-Case-
fig-3

| Part| #| Part| #| Part| #| Part

---|---|---|---|---|---|---|---
ⓐ| HDD / Power LED| ⓑ| Reset Button| ⓒ| Microphone Jack| ⓓ| Headphone Jack
ⓔ| USB 2.0 Ports| ⓕ| USB 3.0 Port| ⓖ| Power Button| |

Removing the side panels

ZALMAN-T7-ATX-Mid-Tower-Computer-Case-
fig-5

Tempered Glass
Steel Panel

Removing the front panel

Mounting the motherboard

Motherboard size

ATX
mATX
Mini-ITX

Mounting the PSU

Mounting the PCI-E(VGA) card

Mounting the 3.5″ and 2.5″ SSD / HDD

Mounting the 2.5″ SSD / HDD

Fans Included / Specifications

RPM : 1100± 10%
Input: 12V 0.24A

Mounting the fans

Mounting the top fans
Mounting the front fans
Mounting the bottom fans

I/O Connectors

To ensure safe and easy installation, please read the following precaution.
Product design and specifications may be revised to improve quality and performance without notice.
www.zalman.com

Documents / Resources

| ZALMAN T7 ATX Mid Tower Computer Case [pdf] User Manual
T7, ATX Mid Tower Computer Case, T7 ATX Mid Tower Computer Case, Mid Tower Computer Case, Tower Computer Case, Case
---|---
| ZALMAN T7 ATX Mid Tower Computer Case [pdf] User Manual
T7 ATX Mid Tower Computer Case, T7, ATX Mid Tower Computer Case, Mid Tower Computer Case, Tower Computer Case, Computer Case, Case