POWERSMITH PILB600UV Foldable LED Inspection Light with UV Instruction Manual

September 4, 2022
POWERSMITH

POWERSMITH logo PILB600UV Foldable LED Inspection Light with UV
Instruction Manual
TOLL-FREE HELPLINE:

888-552-8665
powersmithproducts.com
200/600 LUMEN
FOLDABLE LED
INSPECTION LIGHT WITH UV
POWERSMITH PILB600UV Foldable LED Inspection Light with
UV

  1. Spot Light
  2. Flood Light Panel w/UV
  3. Joint
  4. Battery Power Indicator
  5. Switch Button
  6. Charging Port
  7. USB Power Output
  8. Rubber Cover
  9. Hanging Hook
  10. Magnetic Base
  11. Spring-Loaded Clamp
  12. Charging Cable

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS, CAUTIONS, AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below may result in electric shock, fire, and/or serious personal injury.
WARNING:
Do Not Look directly into LED lights.
Do Not shine the LED light directly into the eyes of others.
Do Not allow children to use LED light unless under the
supervision of an adult.
WARNING: This LED light is powered by a Lithium-ion battery. Lithium-ion batteries are small, compact, and ideal for providing long-lasting power to this product. However, they must be used and charged properly. Improper use can result in serious injury, fire, or death.
CAUTION: This product comes with the battery installed internally. Do not attempt to remove the battery from the product.

  • Do not place this lithium-ion battery-powered product in fire or apply heat to it.
  • Do not apply strong impact or shocks to this lithium-ion battery-powered product.
  • Do not allow the lithium-ion battery to get wet.
  • Do not leave this lithium-ion battery-powered product in the direct sunlight, or use or store it inside cars in hot weather. Doing so may cause the battery to generate heat, rupture, or ignite. Using the battery in this manner may also result in a loss of performance and a shortened battery life.
  • NEVER THROW WATER ON A BURNING LITHIUM-ION BATTERY! If a lithium-ion battery does catch on fire, it will burn even more violently when contacted with water.
  • Store the product at temperatures between 41°F and 77°F (5°C and 25°C).
  • Properly dispose of all batteries at a recycling center or per local code. More information regarding battery disposal in U.S. and Canada is available at;
    http://www.rbrc.org/index.html, or by calling 1-800-822-8837 (1-800-8BATTER).

SPECIFICATIONS

  • Brightness for Spot Light: 200 Lumens, Dimmable
  • Brightness for Flood Light: 600 Lumens, Dimmable
  • Beam Distances (max.): 164 Ft. (Spot Light), 65 Ft. (Flood Light)
  • Ultraviolet Light: 395nm
  • Run Time: 3-4 Hours
  • Battery: 3.7V, 2.0Ah Lithium-Ion, Built-In
  • USB Power Output: 5V,1A
  • Charging Time: 3 Hours
  • Net Weight: 0.5 lb
    Includes: Light, Charging Cable, and Operator’s Manual

CHARGING THE LIGHT

The light can be recharged by connecting the included USB charging cable to a USB power output, such as a cellular phone power adaptor or laptop USB port.

  1. Make sure the light is turned off.
  2. Lift the rubber cover (8) to expose the charging port (6).
  3. Connect the USB-C (small) end of the charging cable to the charging port and connect the USB end to a standard 5V USB power output.
  4. The battery power Indicator lights (4) will illuminate green to show the battery power level. One indicator light will be flashing if charging is in progress.
  5. When charging is complete, all five indicator lights will be solid green.

OPERATION

SWITCH
A SHORT PRESS on the switch button (5) will turn on the light at the mode and brightness memorized from the last turn-off.
Additional SHORT PRESSES on the switch button to rotate the light modes among Spot Light, Flood Light, UV Light, and Off. Make sure no more than 2 seconds pass between each press during the mode selection. If one of the working modes stays on for more than 2 seconds, the next press of the button will turn the light off.
To dim any of the lights, select the light mode you want, and hold (LONG PRESS) on the switch button until the desired brightness level is reached.
BATTERY POWER INDICATOR
The light has a battery power indicator (4) above the switch button. It consists of 5 green lights. To show the battery power level, turn the light on. More illuminated green lights indicate more battery power remaining.
ULTRAVIOLET (UV) LIGHT
The product features a 395nm Ultraviolet (UV) Light for automotive leak detection, HVAC leak detection, forgery or counterfeit detection, crime scene inspection, mineral and
gemstone analysis, and more.
USB POWER OUTPUT
The light has a USB power output (7) to charge other portable devices using the USB cable.
FOING & UNFOLDING THE LIGHT PANELED 
The light panel (7) can be folded to pocket size and unfolded to a working position as shown in FIG 1-B. It also rotates 300° horizontally around the joint (3) for more versatility in your light position.
MAGNETIC BASE
This light has a magnetic base (10) with a hanging hook (9). See FIG 1.
SPRING-LOADED CLAMP
This light features a spring-loaded clamp (11). See FIG 1. To use the clamp, pull the base away from the light body, then clamp it on an object with a thickness of no more than 1-1/8”.
WARRANTY
This product is warranted free from defects in material and workmanship for 2 (Two) years after the date of purchase. This limited warranty does not cover normal wear and tear or damage from neglect or accident. The original purchaser is covered by this warranty and it is not transferable. Prior to returning your product to the store location of purchase, please call the Toll-Free Help Line for possible solutions.
©Richpower Industries, Inc. All Rights Reserved
Richpower Industries, Inc.
736 Hampton Road
Williamston, SC 29697
Printed in China, on recycled paper
POWERSMITH logo

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals