Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide

June 9, 2024
Kimberly-Clark

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide

Kimberly-Clark Standard Roll Toilet Paper Dispenser User
Guide

Use of this Dispenser

Not recommended for outdoor installation or in wet environments. Do not attempt to clean the dispenser with a water jet or by spraying the dispenser directly. Follow the installation and usage instructions. Only use genuine Kimberly-Clark Professional product refills intended for the specific model. The dispenser can be cleaned using a damp cloth and detergent, do not use abrasive cleaning products.

These instructions are available at www.kcprofessional.com.

General Safety Information

This dispenser can be used by children over the age of 8 years old and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, provided they have been given supervision or instruction concerning use of the dispenser by a person responsible for their safety. Access to the service area is restricted to persons who have knowledge and practical experience of the dispenser, in particular as far as safety and hygiene are concerned.

This dispenser is not a toy and shall not be used by children as such. Children shall not perform cleaning or user maintenance of this dispenser. High-risk individuals are not expected to use this dispenser safely unless continuous supervision is given.

*For additional faceplates, contact your sales representative. Not Included

Need more information?
These instructions and additional resources are available at www.kcprofessional.com.

Install Dispense

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Tools
Required

  1. Align bracket to local ADA requirement distance from floor. This will ensure the bottom of the dispenser is at the correct ADA height. Make sure the built-in level on the bracket reads level. Check for regional & local
    installing/mounting requirements.Kimberly-Clark Standard Roll Toilet Paper
Dispenser User Guide - Align bracket to local ADA
requirement

  2. Carefully brace the mounting bracket in place once it is properly located on the wall and mark holes to drill.

  3. Remove the bracket from the wall, leaving just the four marked holes. Drill a hole in each of the four marked locations so anchors** can be inserted.Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Remove the bracket from the wall

  4. Tap in the four anchors in each drilled hole so the bracket can be screwed to the wall.

  5. Bring back the mounting bracket and insert a screw into each wall anchor to secure the mounting bracket to the wall. Screw the mounting bracket to the wall starting with the marked anchor hole. Make sure not to over-tighten the screw and damage the bracket!

** Ensure that proper mounting hardware is used for appropriate wall composition as enclosed hardware may not be compatible with your wall surface.

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Bring back
the mounting bracket

Install Dispenser

  1. Carefully line the mounted wall bracket up to the rear, corresponding bracket pocket of the dispenser backplate to complete installation.Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Carefully line the mounted
  2. Once the mounting bracket is in its designated, corresponding pocket, lower the dispenser backplate until the lock button clicks.Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Once the mounting bracket
  3. Fasten the security screw to completely secure the dispenser to the mounting bracket. Do not over-tighten the security screw!

This is so that the dispenser does not inadvertently become separated from the bracket.

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Fasten the
security screw

Dispenser Access

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Dispenser
Access

Load Product

  1. Remove and discard the depleted soft bath tissue roll(s) if present.
  2. Flex the spring-loaded arms on the left and right out, like shown, and insert the new soft bath tissue rolls into the right side roll holders.
  3. Let the spring-loaded roll arms flex back into the soft bath tissue roll core to secure the new rolls.
  4. Close the dispenser cover, ensuring that the cover is securely locked before removing hand.

Kimberly-Clark Standard Roll Toilet Paper Dispenser User Guide - Load
Product

®/TM Trademarks of Kimberly-Clark Worldwide, Inc. or its affiliates. © KCWW
®/TM Marques de commerce de Kimberly-Clark Worldwide, Inc. ou de ses filiales. © KCWW Parts made in Mexico and China, Assembled in Mexico /  Distributed in the U.S. by Kimberly-Clark Global Sales, LLC, Roswell, GA 30076-2199 Distributed in Canada by Kimberly-Clark Inc., Mississauga, Ontario L5B 3Y5 Kimberly-Clark Europe Limited, Walton Oaks, Dorking Road, Tadworth, Surrey, KT20 7NS, UK. www.kcprofessional.co.uk Kimberly-Clark B.V., Copernicuslaan 35, 6716 BM Ede, Netherlands. www.kcprofessional.fr (FR) or www.kcprofessional.de (DE) Distributed in Australia by Kimberly-Clark Australia Pty. Ltd, Level 4, 100 Arthur Street, North Sydney, NSW 2060 Tel: 1800 647 994 www.kcprofessional.com.au Distributed in New Zealand by Kimberly-Clark New Zealand, Level 2, 123 Carlton Gore Road, Newmarket, Auckland 1023, New Zealand Tel: 0800 447 814 www.kcprofessional.co.nz Distributed in Singapore by Kimberly-Clark Singapore Pte. Ltd, 81 Tuas South Avenue 8, Singapore 637558. Tel: 1 800 562 5275 www.kcprofessional.com.sg 29912 200025 400 6517 268 www.kcprofessional.com.cn

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Kimberly-Clark User Manuals

Related Manuals