Maxxima MCL-80900B Glass Ceiling Light Installation Guide
- June 9, 2024
- Maxxima
Table of Contents
Glass Ceiling Light Installation Guide
MCL-80900B Glass Ceiling Light
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- To insure personal safety, proper grounding of the electrical fixture is required.
- The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.
- Turn off the main power at the circuit breaker before installing the fixture.
WIRING AND MOUNTING INSTRUCTIONS
-
Ensure power has been switched off before starting installation.
-
If you are replacing an exisitng fixture, remove and disconnect the old fixture first.
-
Expose the supply wires from the junction box.
-
Ensure approximately 1/2in of insulation is removed from each wire.
-
Position the supply wires with the white wire (neutral) on one side of the junction box and the black wire (hot) on the other side of the junction box.
-
Fasten the mounting bar to the junction box using the provided screws.
-
Tie the ground wire (green or bare copper) to the fixture bar usng the green screw. Ensure to leave about 3” of excess to connect the bare copper wire from the fixture
using the provided wire nuts. -
Connect the white wire (neutral) from the fixture to the white wire (neutral) from the junction box using the provided wire nuts.
-
Connect the black wire (hot) from the fixture to the black wire (hot) from the junction box using the provided wire nuts.
-
Place the trim over the mounting bar, ensure that no wires are pinched and install the two trim mounting screws.
-
Install the glass shade onto the socket and put the rubber washer and socket mounting nut on the socket and tighten until the glass shade can no longer move.
**Note: Ensure not to let go of the glass shade until secure** -
Install the desird E26 light bulb (not provided).
-
The installation is now complete, restore power and confirm functionality.
3 YEAR WARRANTY
Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
****info@maxximastyle.com
866-MAXXIMA (629-9462)
www.maxximastyle.com
125 Cabot Court Hauppauge, NY 11788
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>