eta Km-5029 Blade Master 5 In 1 Multipurpose Trimmer Instruction Manual

BLADE MASTER
Instruction Manual

Dear customer, thank you for purchasing our product. Please read the operating instructions carefully before putting the appliance into operation and keep these instructions  including the warranty, the receipt, and, if possible, the box with the internal packing

SAFETY WARNING

• Before the first use, read the instructions for use carefully, look at the picture and keep the instructions for use.
• Check whether the data on the type label corresponds with the voltage in your socket.
• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• Before replacement of the accessories or accessible parts (which are moving in operation), assembly, disassembly, cleaning or maintenance, or after the end of use, switch off the device and disconnect it from power mains.
• Always unplug the appliance from the power supply if you leave it unattended and before assembly, disassembly or cleaning.
• Never use the appliance if the USB power cable is damaged, if it does not work properly if it fell to the ground and got damaged. In this case, take the appliance to a special service to check its safety and proper function.
• Use only a safe low-voltage (5 V) power source for the device, complying with relevant standards (e.g. mobile telephone charger with micro USB port, double insulation), output current maximum of 1000 mA.
• To power the appliance, only apply a safe small voltage in accordance with the type plate.
• For additional protection, we recommend the installation of current protection (RCD) with the nominal release current not exceeding 30 mA. Ask a control technician or an electrician for advice.
• The appliance is intended for use in households only and for similar use! It is not designed for use in hair salons or for other commercial use!
• Never immerse the appliance (or any part thereof) in water or other liquids. Never wash in running water!
• Use only the accessories designed for this type. Do not use damaged adapters.
• Never tuck the appliance or the accessories into anybody’s holes.
• Be careful when using the appliance, the blades are sharp.
• Do not use the appliance while having a bath, having a shower, or taking a sauna and for trimming wet or artificial hair.
• Check adaptor blades for deformation/damage on a regular basis.
• The appliance is not intended for operation with an exterior time switch or separate remote control system.
• The appliance is not intended for styling animal hairs.
• Never charge the appliance in direct sunlight or close to heat sources if the temperature is below 10 °C or above 40 °C. If the appliance is fully loaded, unplug the charging device.
• In case the cutting lath gets blocked, the appliance must be turned off immediately and the cause removed.
• The appliance gets hot when charging which is absolutely normal.
• Charge the battery at a temperature close to room temperature.
• Do not dispose of the battery into fire. There is a risk of explosion!
• Do not charge a battery that is leaking electrolyte.
• Do not expose the battery to temperatures higher than 50 °C to prevent damaging the battery.
• Do not put the trimmer on hot heat sources (e. g. oven, stove, radiator,

WARNING

• To power the appliance, only use a source of safe low voltage of 5V which complies with applicable standards (mobile phone chargers with a micro USB connector with
  double insulation are suitable). Do not use USB ports on other devices (e.g. computers, laptops, tablets, mobile phones, etc.) to power the appliance. Such devices may not be dimensioned for the current consumption of the appliance and it could damage them.

 DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)

A – Trimmer
A1 – ON/OFF/lock switch
A2 – Socket for charging
A3 – LED indicator
B – Combs
B1 – Universal hair-trimming adapter
B2 – Adjustable comb adapter 1-10 mm (compatible with universal hair-trimming adapter B1)
B3 – Beard trimming adapter
B4 – Body hair-removing adapter
B5 –Nose, ear, and eyebrow hair removing adapter
C – Blade lubrication oil
D – Brush
E – USB cable
F – Practical storage tray for the appliance and accessories

INSTRUCTIONS FOR USE

Before you can use the appliance, its batteries must be charged. The operation time for one charge depends on the attachment used and workload. The attachment is around 60 minutes.
To Charge/Recharge

• Fully charge Clipper before using it for the first time or after non-use for a long period of time.
• Battery performance is best if you recharge only when the battery is (almost) completely empty.
• Charging or recharging at temperatures below 10°C or higher than 40°C adversely affects the lifespan of the battery.

• Continuously recharging Clipper will reduce the lifespan of the battery.
  LED indicator (A3)

  Red light| Charging
  Greenlight| Charging completed

1. Be certain Clipper is OFF.
2.  Connect the trimmer to the adapter and plug the adapter into the mains.
3. It will take approximately 2 hours to fully charge the Clipper. Do not exceed the set time of charging!
4. After charging, unplug the adaptor from the mains first and only then unplug the connector from the appliance.

Optimize the working life of the battery
– Do not charge for more than 2 hours.
– Do not keep the cord permanently plugged in.

USE
Use switch A1 (Fig. 1) to switch on/off the appliance:
position “I” – on
position “0” – off

Remarks

• Use the appliance only for dry hair.
• Choose the relevant adapter type and put it on correctly (see Fig. 1, 2).
•  If the trimmer becomes blocked, switch it off immediately and unblock it.
• Combine the hair/beard in the growth direction before trimming.
• For the best result of trimming, move the appliance against the hair/beard growth direction.
•  Switch off and clean the trimmer after use.

Trimming hair/beard
Adapters B1 and B2 are intended for trimming hair/beard:

1. Be careful when trimming without the comb adapter. The trimmer could remove the entire hair/beard it touches.
2. When trimming the contour, bend the trimmer so that only one edge of the trimming head touches the ends of the hair/beard.
3. Use the trimmer to mark the line of hair/beard, and then trim off the hair exceeding this line.
4. When starting trimming, use comb adapter B2 and set the maximum length on it (10 mm). Then you can set shorter length values gradually.
5.  Move the trimmer slowly on the surface in various directions to obtain an equal haircut.
6. All places should be trimmed several times to cut off all hairs/beards that should be removed.
7. Trim carefully over a brush to achieve an even cut of the mustache. If you prefer using your finger as a guide, proceed accordingly.

Shaving
Use adapter B3 for shaving:

1. If necessary, shorten the beard to a minimum (approx. 1 mm).
2. Press the appliance moderately on the face skin and shave the beard as required.

Removing hairs on the body
Use adapter B4 for removing hairs on the body:

1. Press the appliance moderately on the skin and remove the hairs as required.
2. Be careful when trimming hair on sensitive parts of the body to avoid injury.

Trimming Nose Hair
Use adapter B5 for removing thin hairs in the nose:

1. Make sure nasal passages are clean.
2. Switch the Clipper on and insert the tip of the attachment into one nostril.
3. Slowly move the tip in and out while turning it around at the same time in order to remove unwanted hair. For best results, make sure the side of the tip is firm against the skin. This will reduce the tickling effect that can occur during the trimming of nose hair.
4. Turn off, Clipper. Wipe the attachment clean after each use.

CAUTION
Do Not insert the tip more than 5 mm into your nostril.

Trimming Ear Hair
Use adapter B5 for removing thin hairs in the ears:

1. Clean the outer area of the ear and ear canal. Make sure it is free of wax.
2.  Switch the Clipper on and move the tip softly around the edge of the ear to remove hairs extending beyond the outer ear.
3. Carefully insert the tip into the outer ear canal.
4. Turn off, Clipper. Wipe the attachment clean after each use.

CAUTION
Do not insert the tip further than 5 mm into the ear as this could cause damage to the eardrum.

MAINTENANCE

Do not use rough and aggressive detergents! Wipe the trimmer surface with a wet soft cloth.
Cleaning the adapter
Clean the adapters with a small brush D (included). In order to keep the trimmer in perfect condition, you have to lubricate the list with blades using one or two drops of oil for sewing machines. Do not use hair oil, petroleum jelly, or oil mixed with petrol or any other solvent because after evaporation the solid parts of the lubricant could slow down the operation of the blades. Insert the trimming head to the trimmer properly, turn on the trimmer and then turn it off and wipe out the excessive oil from the blades.

Storage (fig. 3)
Put the trimmer with the accessories back to the original package in a dry and dust-free place, out of reach of children and incapacitated people. Use tray F for storage of the device.

ENVIRONMENTAL PROTECTION

If the dimensions allow, there are marks of materials used for the production of packing, components, and accessories as well as their recycling on all parts. The symbols specified on the product or in the accompanying documentation mean that the used electrical or electronic products must not be disposed of together with municipal waste. For proper disposal, hand them over at the special collection places where they will be received free of charge. Suitable disposal of the product can help to maintain valuable natural resources and to prevent possible negative impacts on the environment and human health, which could be the possible consequences of improper waste disposal. Ask for more details at the local authorities or at a collection site. Fines can be afflicted for improper disposal of this type of waste in agreement with the national regulations. The appliance is equipped with rechargeable Li-ion batteries with long life. Dispose of the batteries in a suitable and safe way through the special collection networks. Never dispose of the batteries by burning them!

TECHNICAL DATA

Voltage (V)
Trimmer weight (kg)
Appliance Protection Class
Accumulator
Dimensions (H x L x W)| specified on the type label
0.09
III.
3.2 V Li-Ion
53 x 177 x 42 mm
---|---

Noise level: Acoustic noise level of 63 dB (A) re 1pW.

The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
More extensive maintenance or maintenance requiring intervention in the inner parts of the appliance must be carried out by professional service! Failure to comply with the instructions of the manufacturer will lead to the expiration of the right to guarantee repair!
A guarantee of 24 months does not apply to a decrease in the accumulator’s effective capacity caused by its use or age. Effective capacity gradually decreases depending on the method of use of the accumulator.
Oil: Warning, Avoid contact with eyes, Do not drink, and Keep away from children or mental capabilities.

HOUSEHOLD USE ONLY. DO NOT IMMERSE IN WATER OR OTHER LIQUIDS.
TO AVOID THE DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS,  CARRIAGES, OR PLAYPENS. THIS BAG IS NOT A TOY.

water containers.

Notes

© DATA 26/11/2021

References

• AEG Hausgeräte | Setzen Sie auf Qualität | AEG
• ETA - tady je doma
• ETA - tu je doma

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>