achim B097FD6V5Q GII Luna Light Filtering Mini Window Blinds Instruction Manual

June 15, 2024
ACHIM

User Manual
140W GaN II PD Fast Wall Charger

B097FD6V5Q GII Luna Light Filtering Mini Window Blinds

Thanks for choosing Unitek 140W GaN II PD Fast Wall Charger which enables you to quickly charge your smartphone and laptop. Please read this manual carefully and if you need any further assistance, please contact our customer support team at: support_us@unitek-products.com.

Installation Instructions for GII Cordless Luna 2-inch Vinyl Plantation Blind

achim B097FD6V5Q GII Luna Light Filtering Mini Window
Blinds

STEP 1. Attach the Brackets
To install the end brackets, first determine where to attach each bracket.
If you are installing an outside-mount blind on a window (Fig. A), position the bracket on the window frame or on the wall above the frame and attach with the proper fasteners.
If installing outside-mount blind on a door (Fig. B), position the bracket with a spacer block (not included) on the door above the glass panel and attach with screws. The spacer block must be between the door and the bracket.
If installing inside-mount blind (Fig. C), position top of bracket against inside surface of window frame and attach as shown. Each end bracket uses at least two screws. Make sure end brackets are level.
For the blinds over 32″ wide and less than 45”wide, a center support bracket will be provided. Blinds larger than 45”wide will have two center support brackets provided. To install the support brackets (Fig. D) center the support bracket  between the two end brackets. Keep the top and back of each support bracket level and aligned with the top and back of the end brackets. If more than one support bracket is used, space the support brackets evenly across the width of the  headrail. Insert screws in the top for an inside mount; insert screws in the back for an outside mount (Fig. D1).

STEP 2. Install the Headrail
Position one valance clip at each end of the headrail, and evenly space any additional clips across the width of the headrail (Fig. E). Slide the headrail into the end brackets and center support (Fig. F). Then close end bracket covers until  they click into place.

STEP 3. Install Valance
Your blind includes a valance (a slat). Put the valance under the upper clap of each clip. Then bend and guide the entire valance into the bottom clamps. (Fig G.)

STEP 4. Attach Hold-Down Brackets (Optional for Door only)
To install the hold-down brackets, lower the blind all the way down. Position bracket close enough to the bottom rail so that the hold-down pin lines up with the hole and the hold-down bracket (Fig. H). Attach the hold-down brackets  with screws. Insert the pins into the center of each side of the bottom rail.

OPERATING INSTRUCTIONS:
To Tilt The Blind:

  • Rotate the wand in either direction to fully open and close the slats to the desired angle.
  • To Lower and Raise The Blind:
  • Tilt the slats to the fully open position first. (Parallel with headrail).
  • Grasp bottom rail firmly on both sides evenly and pull down gently until reaching the desired length.
  • To raise the blind, simply grasp both side of the bottom rail and raise slowly to desired position.

TROUBLE SHOOTING:
Problem/uneven bottom rail:
Pull the blind down evenly on both side and adjust both side when raising the blind up again.
Note: This blind cannot be shortened.

Achim Home Décor: 1-800-54-ACHIM
Customerservice@achimonline.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals