Holmes 12095 45” Digital Tower Fan Instruction Manual
- June 13, 2024
- Holmes
Table of Contents
Instruction Manual
Itern: 12095
Model: 32510341 45 Inch
Digital Tower Fan
MD SAVE THESE IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliancess basic safety precautions should always be token including the following:
- Read on instructions befogs usinl this appliance.
- Use fan only for purposes dosuibed in the instruction manual.This fan is not for continuous operation or enviroment.
- To protect against electrical shock do not immerse unit plug or cord in water or spray with liquids and plug the appliance directly into a 120V AC electrical outlet.
- Close supervision is necessary when any appliance is used near children.
- Not inclended for use by children
- Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off parts and before cleaning.
- Avoid contact with moving parts.
- Do not operate in the presence of expbsim and/a flammable fumes.
- To avoid fire hoard. NEVER place the cord under rugs or any ports near on open flame, cooking or other healing appliance.
- Do not operate any appliance with a damaged cord or plug after the applicnce molfundions, or has been droppad/domaged in any neormer. Discord fan Of contact customer service.
- Do not run cord under careering. Do not Wolf cord with throw rugs, runner, or similar coverings. Do rat route (Old under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- The use of attachments not recommended or sold by the appliance manufacturer may cause bands.
- Do not let the cord hang over the edge of a table, counter or come in contact with hat surfaces or leave exposed to high traffic areas.
- Do not use outdoors.
- To disconnect, grip plug and pull from wall outlet. Neter yank on cord.
- Always use on a dry, level surface.
- Do not operate fon until fully assembled with cll parts properly in place.
- This product is intended for household use ONLY cnd rat for commercial or industrial applications.
- WARPING: To reduce the tisk of electrical shock end inhg y to persons, do not use in window.
- WARNING: To reduce the risk of fire or electric shock, do not use this fon with any solid-state speed control device.
- WARPING: This product employs overload protection (fuse). A blown fuse in&cotes on overload or short circuit situorion. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instrixtions follow product marking for proper fuse rating check the product. If the replecemt fuse blows, a shall circuit may be present and the product should be discarded or contort customer service.
WARMING: Chemical Burn Harald. Keep tummies away from children. This
product contains a lithium button/coin cell battery. If a new or used lithium
button/coin cell battery is swallowed or enters the body, it can cause severe
internal burns end can lead to death in as little as 2 hours. Always
completely secure the bonny comportment. If the battery comportment does not
close securely, stop using the ‘Redo, remove the benefits, and keep it away
from children. If you think batteries might have been swallowed or placed
inside ony pall of the body, seek immediate medical attention.
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other).
To reduce the risk of electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY.
FEATURES – OPERATIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS: (SEE FIGURE I & 2)
Estimated assembly time: 5-10 minutes
Tool free, I thumb screw included
NOTE : MAKE SURE YOU REMOVE ALL CONTENTS FROM THE PACKAGE. PLEASE CHECK
PACKAGING MATERIALS FOR PARTS THAT COULD BE REOUIRED TO OPERATE THIS FAN.
- To secure the Base Holies (f) together, slide the posts of one bass half into the slots of the second base half. (Refer to Figure 2.)
- Pull the power cord through the (enter hole of the base.
- Position the power cord into slot of the bottom of the base and into the rear base slet.
- Hold the Fan Housing 3 (E) onto the assembled base and turn the boss clockwise until it no longer turns and locks in place. install thumb screw to secure.
- Place the assembled Fan Housing 3 (E) with rho Base right side up and place on a dry and level sulfate.
- Insert Fan Housing 2 (D) into Fon Housing 3 (E) and match the location icon “ ****‘. Turn clockwise to lock into position. Once locked into position, verify the housing is secured and does not rotate.
- Insert Fan Housing 1 (C) into Fan Housing 2 (3) and match the location icon “ ****“. Turn clockwise to lock into position. Once locked into position, verify the housing is secured and does not rotate.
OPERATING INSTRUCTIONS: (SEE FIGURE 3)
- Plug the cord into a standard 120 volt AC outlet.
- To turn the fan on, press the POWER button (A) located on the control panel or remote control, indicator light will be on. The fan will start running on speed 3.
- Press the speed button (8) to cycle through 4 speed settings in sequence. the corresponding indicator light will illuminate.
- To turn the oscillation on and off, press the OSC button (D) located on the control panel or remote control.
- To thong. the mode, press the MODE button (E) to cycle though the mode selection; indicator light will be on to indicate the Normal, Breeze, Sleep, or Poore Breeze modes.
- To set your fan to automatically shut off, press the timer button (C) located on the control pone) or the remote control. When set, the fon will run and automatically shut off after the set duration of tine (I, 2, 4, 8 hours) has expired.
- To silence setting confirmation beeps, press the MUTE button (F) located on the remote control; MUTE icon on the LED display will be on. Press the button again to roodivote setting confirmation beeps; MUTE ken on the LED display will be off.
- To turn the fan off press the pat button (A) located on the control panel or remote control.
NOTE Your fon features o LED display panel. When u specific feature is actheted on your fan, the LED panel will illuminate with the corresponding ‘fronts) showing which features have beer activated.
DISASSEMBLY INSTRUCTIONS:
- Make sure the fon has been cnplugged before disassembly.
- Push and hold the lacking knob in place. By holding the base in place , turn Fan Housing I (C) anidockwise to release .
- Repeat Step 2 to release Fan Housing 2 (D).
- Pull the Base Tab (I) and rotate the base anidockwise while keeping Fan Housing 3 (E) in place to unlock the base from the fun housing. Remote thumb screw.
- Pull the power cord out through the centre hole of the boat.
- Store the disassembled fan pieces in the proided storage bag (0).
REMOTE CONTROL: (SEE FIGURE 4) NOTE: PLEASE REMOVE THE PROTECTIVE PLASTIC
FROM THE REMOTE CONTROL BATTERY BEFORE OPERATION. This unit includes one
lithium battery, CR2025/3V.
Remore battery before discarding tbe remote.
Belay Replacement
The cells shoild be disposed of properly, including keeping then Doty from
children. ben used cells may cause injury.
a) Locate the battery comportment 0n the bottom back of the rontme control
handset. Push and pull battery tray.
b) Remove old battery.
c) Place new battery into battery comportment.
d) Slide battery compliment into the remote control handset.
NOTES:
- Remove the busty from the equipment when it is not being used for an extended period of time.
- Remove the used battery promptly.
- Do not discord used batteries into household trash containers. Contact your locol goverment for disposal or recycling proctices in your area.
CLEANING / MAINTENANCE
CLEANING/MAINTENANCE INSTRUCTIONS
Follow these insrructions to correctly card safety core for this fan. Please
remember:
REPLACEABLE FUSE
If the (2.5 Amp, 125 volt) replaceable fuse blows, please visit our websile
at www.getholmesfans.com for information on
how to order a new fuse. Follow the below instructions to replace ihe fuse on
the plug.
User Servklug Instructions
-
Unplug the fan. Grasp plug end remove form the receplease or other outlet device. Do not unplug by pulling on cord.
-
Open fuse cover, located on the top of the plug, by wsing your thumb or a flotheod srewdriver 1o dide the cover down towards the prongs.
NOTE Insure thoi fuse cost is complesdy open befxe attempting to romove fuse. -
Remote fuse carefully In using a small screwdriver to pry the fuse out of the compartmetn by the metal ends of the fuse. (see figure 5)
-
Place plug on a sed, flat surfae. insert new 25 Amp, 125 volt fuse into fuse compartment and use a small screwdriver to wise the metal ends of the fuse into the compartment .
CAUTION:
Risk of fire. Replace fuse only with 25 Amp, 125 Volt fuse. -
Slide fuse cover closed completely. If fuse cover is difficult to close; make sure fuse is secured in place completely by pressing down on metal ends of the fuse.
-
Risk of fire. Do not replays attetment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attetment plug is domeged.
FAN CLEANING
- Always unplug the fan before Cleaning.
- Do not allow utter to drip on or enter into fan housing.
- Be sure to use a soft cloth moistened with u mad soap solution.
- Do not use gasoline, thinner or benzene as a cleaner.
Clean the fun grill, housing and base with a soft, damp cloth. Do not attempt to remove the fan blade. Please use caution around the housing yea. Do not allow the molar or °thee electrical components to be exoosd to utter.
FAN STORAGE
When shying this fan in the off season, it is important to keep it in o safe
thy location. It is important to protect the fan from dust.
For inquiries regarding recycling and proper disposal of this product, please
contact your local waste management facility.
FCC STATEMENT
Potential for Radio/Television Intaforeace
This device complies with Port 15 of the FCC Rules. Operation is subject to
the following two conditions:
(I) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This product has been tested and found to comply with the limits for a closs B
digital device, pursuant to pert 15 of the FCC rules.
These limits ore designed to provide reasonable protection against harmful
interference in a residential installation. The product generates, uses, and
con radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that the interference will not
occur in a particular installation. tf the product does cause harmful
interference to radio !derision reception, which can be determined by turning
the product on or off, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the waving antenna.
- Increase the separation barmen the product and the receiver.
- Connect the product into an outlet on o circuit different from that to which the receiver is connected.
- Consult the dealer or on experienced radio/TV technician for help.
- Changes or modifications not expressly approved by the party responsade for compliance could void the user’s authority to operate the equipment.
The following importer is the responsible party:
Company Name: SEG Products US Corp.
Address: 8 The Green, Suite 86962, Dover, DE 19901
Telephone: 1.959.202-4223
WARRANTY INFORMATION
3YEAR LIMITED WARRANTY
This device has a limited warranty of 3 year from the original date of
purchase against workmanship and defects in material. If under normal use,
your product fails to operate, please contact our customer service department
at info@getholmesfans.com. A refund or
replacement will be provided to you with proof of purchase. Star Elite Inc.
may deny claims of damage caused by misuse or modifications of this product.
How to Obtain Warranty Service
If you have any problems, please do not contact the store.
Contact our customer service at
1-866-769-3166 (8:30 am – 5:00 pm EST)
Monday – Friday or contact us at
info@getholmesfans.com.
Our customer service will be happy to assist you.
www.getholmesfans.com
© 2021 Sunbeam Products, Inc. All rights reserved.
HOLMES® is a registered trademark of Sunbeam Products, Inc. used under
license.
Distributed by Star Elite Inc., Montreal, Canada H3B 3X9
SEH012-112621
Printed In China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>