STEGO CP061 50W Flat Heater User Guide
- June 4, 2024
- STEGO
Table of Contents
STEGO CP061 50W Flat Heater User Guide
Safety considerations
WARNING
There is a risk of personal injury and equipment damage if the connection
values are not observed or polarity is incorrect!
WARNING
Hot surfaces following commissioning! Risk of injury
- Installation must only be performed by qualified electrical technicians in observation of the respective national power-supply guidelines (IEC 60364).
- The safety measures according to VDE 0100 are to be ensured.
- The technical specifications on the type plate must be strictly observed!
- The user of the heater must ensure through installation that components which are mounted above the air outlet grating are not damaged by the hot outlet air.
- The device must be connected to mains via an all-pole disconnecting device (with contact gap of at least 3 mm in the switched-off state).
- The device must not be operated in environments with aggressive atmospheres.
- No changes or modifications must be made to the device.
- In the event of any damage to or malfunction of the heating unit, the device must not be repaired or put into operation (dispose of the heating unit).
- Dismantle the heater only after it has cooled down
Attention! The heater must not be mounted on flammable materials (e.g. wood, plastic etc.).
Notice
The manufacturer accepts no liability in the case of failure to observe this
brief instruction, improper use and changes or damage to the device.
USAGE
The flat heater is used to avoid condensation and ensure a minimum operating temperature in switch cabinets. The flat heater is designed for continuous operation. It can be used as a convection heater or contact heater. In the event of a fault due to excess temperature, it is switched off by a temperature monitor with an automatic reduction function. To control the temperature, a suitable thermostat should be connected in series to the flat heater. The maximum surface temperature depends on use and on the installation situation. The flat heater must not be used as a room heater.
Specifications
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>