eta 5595 Stainless Steel Double-Wall Electric Kettle User Manual
- October 30, 2023
- ETA
Table of Contents
eta 5595 Stainless Steel Double-Wall Electric Kettle User Manual
INSTRUCTIONS FOR USE
Dear customer, thank you for purchasing our product. Keep these instructions
including the warranty, the receipt and, if possible, the box with the
internal packing.
I. SAFETY WARNING ⚠
GENERAL PROVISIONS:
-
Before the first use, read the instructions for use carefully, look at the picture and store the instructions for use for the future. Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
-
Check whether the data on the type label correspond with the voltage in your socket. The power cord plug has to be connected to the properly connected and grounded socket according to the national standard.
-
This product can be used by children at the age of 8 years and older if they are supervised or if they were instructed regarding use of the appliance in a safe way and if they understand possible risks. User cleaning and maintenance must not be performed by children if they are younger than 8 year and unsupervised. Children younger than 8 years must be kept out of reach of the appliance and its power cord.
-
The device may be used by persons with reduced physical or mental abilities or lack of experience and knowledge only if they are under supervision or they have been instructed about using the appliance safely and understand the potential dangers.
-
Children must not play with the appliance. The electric kettle is intended for heating the maximum of 1.5 l
of water. If the water level exceeds the maximum recommended amount, hot water may be splashing out. -
WARNING : Do not open the lid if the water is boiling or if it is hot.
-
CAUTION - Do not use the appliance with a program, time switch or any other part that turns the appliance on automatically as there is a risk of fire if the appliance is not covered or placed properly.
-
When the appliance is in operation, prevent pets, plants or insects to get in contact with it.
-
Do not plug the fork of the supply cord into the power outlet and do not unplug the cord with wet hands or by pulling by the supply cord!
-
Use the electric kettle with the stand designed for this type only and only for its intended purpose.
-
Prevent injuries when handling (e.g. by hot water, steam ).
-
The appliance is equipped with the heat safety lock which disconnects power supply if the steam sensor fails, if water boils away or if an empty kettle is turned on. If it happens, unplug the appliance from power supply and let it cool down. Do not fill the kettle with cold water in order to cool it down quickly. It could reduce life of the heating element.
-
Use this appliance only for the purpose for which it was designed as specified in this user`s manual. Never use the appliance for any other purpose.
-
The producer is not responsible for damage caused by improper use of the appliance (e.g. burning, scalding, fire) and its guarantee for the appliance does not apply to situations when the safety warnings above are not complied with.
USE OF THE APPLIANCE:
- Use the electric kettle with the stand designed for this type only.
- Never immerse the electric kettle and the stand in water and other liquids (even partially)!
- Never leave the appliance unsupervised and check it during the whole time of water heating!
- This appliance is not intended for outdoor use.
- The appliance is intended for home use and similar (in shops, offices and similar workplaces, guests in hotels, motels and other residential environments, in facilities providing accommodation with breakfast, in agriculture). It is not intended for commercial use!
- Use the appliance in the working position only at places with no risk of turning over and in sufficient distance from heat sources (e.g. heater, stove, cooker, oven, grill), flammable objects (e.g. curtains, drapes, etc.) and wet surfaces (e.g. sinks, wash basins, etc.).
- Do not place the appliance near objects or under objects which could get damaged by steam, e.g. walls, kitchen cupboards, sideboards, paintings, or curtains. Leaking steam could damage them.
- Do not use the appliance in an environment saturated with explosive or flammable steams.
- There must be water in the electric kettle before putting into operation. Do not fill the electric kettle with water if it is on the stand.
- Thanks to double layer technology, the most of the outer surface of the electric kettle is insulated against hear. Therefore, you can touch it with your hand, even after boiling. Nevertheless, avoid contact with the outlet of the kettle during and after boiling and watch for the steam escaping from the kettle!
- Before switching on the kettle ensure that the water level is between MIN and MAX marks
- If you are not going to use the electric kettle for longer time, we recommend unplugging the stand from power supply by taking the fork of the power cord out of the socket.
POWER CORD:
- If the power cord of the appliance is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
- Never use the appliance if its power cord or plug is damaged, if it does not work properly, if it fell down and was damaged or if it fell to water. In this case take the appliance to a special service to check its safety and proper function.
- Never put the power cord on hot surfaces or do not let it hang over the edge of a table or a work top. Plugging or pulling the power cord e.g. by children can result in tilting over or drawing the appliance down and serious injury!
- The power cord must not be damaged with sharp or hot objects, open fire, it must not be sunk into water or bent over sharp edges.
II. DESCRIPTION OF THE APPLIANCE
A - electric kettle
A1 - ON/OFF button
A2 - Set Temperature/Functions button
A3 - handle
A4 - lid
A5 - lid lock button
A6 - LED display
B - removable stand
B1 - central connector
B2 - power cord
- The control electronics ensures the appliance turns off automatically after the set temperature or boil of water has been reached.
III. INSTRUCTIONS FOR USE
Before the first use, fill the electric kettle with clean water to the maximum level, turn it on and let the water boil. Then pour out the water and repeat the procedure several times (at least five times).
APPLICATIONS
Unwind the necessary length of the power cord B2 from the storage space of the stand B. Place the stand on a suitable surface, in the height of about 85 cm, out of reach of children and incapacitated persons and plug the fork of the power cord to the electric socket. Hold the kettle A on the handle A3. Open the lid A4 by pressing the lock button A5. Fill the kettle with drinking water. Minimum and maximum water level is indicated on the water level scale inside the electric kettle. Close the lid by snapping. Put the electric kettle on the stand (sound signal will be given, signal lamps over A1 and A2 will flash once, and water temperature will be displayed on A6). Required temperature can be set by short pressing A2. Start the boiling process by short pressing of button A1 ( signal lamp will light up on display A6, over the ” ” sign). Then wait until the heating process is completed (sound signal). Standard heating to the preset temperature and maintaining temperature (KEEP WARM) functions can be switched over by long pressing A2. During the heating phase, preset temperature can be changed by pressing A2. The heating phase can be interrupted by short pressing A1. After approx. 20 minutes of inactivity, the kettle will be switched off automatically.
• 40 °C = infant formula milk,
• 50 °C = baby foods,
• 60 °C = hot beverages,
• 70 °C = green tea,
• 80 °C = white teas,
• 90 °C = oolong teas, coffee, instant drinks, soups,
• 100 °C = black, herbal teas.
Note
If you are going to heat up water to a low temperature (40-70 °C), it is
advisable to have at least 0.7 litre of water in the kettle to reach the
preset temperature more accurately. In the case of a lower volume, the actual
temperature may exceed the preset temperature.
Always use fresh drinking water for boiling. The temperature and time heating depends on the amount of water and the initial temperature of water. For the correct temperature setting, follow the manufacturers` instructions that are described on food packages (e.g. tea, coffee, instant drinks, soaps, etc.).
Temperature maintenance feature
When in stand-by mode, press and hold A1. Green signal lamp will start
flashing on display A6, over the ” ” sign. Then continue by setting the
required temperature. After preset temperature has been reached, sound signal
will be given and the maintaining temperature function will be activated
automatically (signal lamp over the ” ” sign will light continuously). This
function will remain active for approx. 2 hours, then the device will be
switched off automatically. This function can also be deactivated by pressing
A1.
Memory (for Keep Warm function)
The electric kettle is equipped with memory function. It can be used if the
kettle has been switched on and the Keep Warm function active. If the kettle
will be removed from its base in the Keep Warm mode, and then put on it again,
it will continue keeping the temperature. Press A1 to switch off the kettle
and disable the memory.
Notes
- If the kettle is not on the base plate, the electronic operation system is not active.
- If the heating temperature is lower than current water temperature in the kettle, the kettle will be switched on and waiting until the temperature drops to the set value (sound signal will be given).
- If you are preparing food for very young children (e.g. to 40 °C), the water must be heated to a boil (100 °C) first.
- When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
- In bigger tilting of the electric kettle backwards, particularly when it is filled up to maximum, water can flow out from the electric kettle in the bottom part of the kettle. This does not affect safety or other functions and it does not mean any failure of the electric kettle. In the case of tilting the electric kettle with hot water there is a risk of scalding. Therefore do not tilt the electric kettle.
- During heating, current temperature will be displayed until the set temperature value is reached. Then preset temperature will be displayed. The temperature sensor is located at the bottom of the kettle, consequently, the temperature will be displayed with a small tolerance, due to temperature difference in the bottom and upper part of the kettle.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord out of the socket! Clean the kettle only when it is cooled down! Do not use rough and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The housing of the kettle is made of high-quality plastic, the heating bottom and inner surface of the kettle are made of high-quality stainless steel, however, a slight sediment (scale) during standard use /particularly, above the heating element/ cannot be avoided. It is not rust or another material defect of the kettle container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill
the kettle to about one half and mix. After it dissolves, fill the kettle to
3/4 of the maximum amount of water. Place the electric kettle on the stand and
turn it on. Before boiling, turn off the kettle, let the solution take effect
for about 10 minutes and then pour it out. Clean the kettle thoroughly with
clean water. Repeat the whole procedure if the kettle is too soiled. Clean the
electric kettle regularly!
Expert service must do the large maintenance or to intervene into inside parts of the appliance! Non-observance of the instructions of the manufacturer cancels the right for guarantee repair!
If you are unable to fix the problem, or if you need any further information about the appliance or service centres, please contact your distributor.
V. ENVIRONMENT
Printed signs of materials used for manufacture, packing, components and accessories, as well as their recycling, are on all the pieces if their dimensions enable it. The symbols on the product or in the accompanying documentation mean that the used electric or electronic products must not be disposed together with municipal wastes. Please, hand them over to the collection points designed for their correct disposal, where they will be accepted free of charge. By correct disposal of this product you can help to preserve valuable natural resources and help to prevent possible negative impacts to the environment and to human health, which could be the results of incorrect waste disposal. For further details ask the municipal authorities or the nearest collecting point. Penalties can be charged for incorrect disposal of such wastes, according to national regulations. If the appliance is to be put out of operation definitely, we recommend cutting off the feeder cable, to disable its use.
VI. TECHNICAL DATA
Voltage (V) shown on the type
label of the appliance
Absorbed power (W) shown on the type label of the
appliance
Max. volume (l) 1,5
Weight (kg) approximately 1.1
Protection class of the appliance I.
Size (mm): 217 x 235 x 155
Input in standby mode is < 0,50 W
The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE INSTRUCTIONS MANUAL:
HOUSEHOLD USE ONLY; DO NOT IMMERSE IN WATER OR OTHER LIQUIDS;
TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG
IS NOT A TOY.
The ⚠ symbol indicates a WARNING.
© DATE 13/07/2022
e.c.25/2022
References
- AEG Hausgeräte | Setzen Sie auf Qualität | AEG
- Serwis Digison
- ElektroEko – Odbiór odpadów elektro
- ETA - tady je doma
- ETA - tu je doma