OPT7 2009 to 2018 Dodge Ram RGBW Bluetooth Headlights Installation Guide
- June 9, 2024
- OPT7
Table of Contents
RGBW BLUETOOTH
HEADLIGHTS
2009-2018 DODGE RAM
INSTALLATION MANUAL
2009 to 2018 Dodge Ram RGBW Bluetooth Headlights
INSTALLATION
Open the hood.
Please find the 6 points marked in Figure 1 and remove the plastic
fasteners (6x) from the filler panel. Remove the filler panel.| Remove the 10mm
bolts (4x) from the grille as shown in Figure 2.
Next, remove the grille by lifting and pulling forward.
Remove the 10mm bolts (2X) from the OEM headlight as shown in Figure 3.|
Remove the plastic fastener to open the access flap.
Now , let’s push the white latch up to unlock and release the OEM headlight.
Unclip the electrical connectors on the back of the headlight housing.|
Reattach the electrical connectors to the new headlight housing.
Ensure the wires are tied up securely to ensure wires are organized and store
away from any metal surface.
Install the Aura Control Box by connecting the positive wire for a constant on functionality (always on when battery is on) or an accessory wire (only on when the vehicle is on) which can be found in the Fuse Box. Connect the negative wire to a ground wire.
Connect the round connector from
the headlight housings to the control box.| Line up the headlight housing
mounting tabs and push
rearward to seat it in place.
Reinstall the 10mm bolts (2X) to secure
the new headlight as shown in Figure 10.| Test out your headlights using the
OPT7
App.
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>