OPT7 Redline LED Tailgate Brake Light Bar Installation Guide
- June 9, 2024
- OPT7
Table of Contents
Redline LED Tailgate Brake Light Bar
Installation Guide
WHAT’S INCLUDED
STEP1
Test the Redline LED Bar for function before mounting on vehicle.
STEP2
Remove tailgate from vehicle
STEP3
Thoroughly clean the area where the Redline LED Bar will be mounted.
OPTION 1
STEP4
Apply the Adhesive Promoter to the cleaned area.
STEP5
On the Redline LED Bar, peel the back off of the adhesive and apply firmly to
the cleaned area.
OPTION 2
STEP4
Mark out where you want to mount the included clips taking straightness and
placement into consideration.
STEP5
Use the included screws and clips to solidly mount the Redline LED bar to the
vehicle. OPTION 2
STEP6
Plug the 4-pin flat connector into the proper receptacle on the vehicle. Refer
to the wiring diagram below.
Optional: If hard-wiring, use image below to identify wire color functions and pair them to appropriately identified wires on vehicle.
STEP7 WHERE TO CONNECT THE REVERSE SIGNAL ?
Splice the white wire coming from the Redline LED Bar to the factory tail
light or the 7PIN trailer towing socket (Middle PIN) using the SCOTCH-LOK
wiring connector we provided.
STEP8
Test the Redline LED Bar again for function.
NOTE
If you experience any error codes or dash lights, please install the optional
Tailgate Module between the vehicle and Redline LED bar sold separately.
DISCLAIMER
OPT7 Lighting is not liable for damages, injuries, or death while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation. If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
2 YEAR WARRANTY
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>