OPT7 Redline F150 Connect Adapter User Manual
- June 9, 2024
- OPT7
Table of Contents
OPT7 Redline F150 Connect Adapter
NO BLIS/BACKUP CAMERA/ASSIST SENSOR
Hello Fellow OPT7-ites, Introducing the Redline Quick Connect Harness to Flat
4-Pin Extension Adapter Harness
The OPT7 Redline Quick Connect Expansion Adapter Harness is purpose-built to
be used as a trailer accessory for 18-20 F150 models. It provides a plug-and-
play style that allows you to quickly, seamlessly and virtually hidden
installation without cutting or splicing your factory harnesses.
Installation
-
Open up your tailgate first.
Next, locate the two bolts that lock the tail light (See Figure 1) and loosen them. -
Slowly move the loose tail light until it is completely removed (See Figure 2).
Important
There are two plastic clips on the inside of the tail light for fixing, please
be careful not to break it when removing it.
- Locate the OEM wiring harness
(See Figure 3) and unplug it from the tail light assembly by lightly pressing the Release-Latch on the connector.
HOW TO CONNECT
PnP EXPANSION ADAPTER TO YOUR TAILLIGHTS
- Step 4Step
To make it easier for you to identify the signal location represented by the Connector/Wiring. Please read the relevant wiring instructions carefully before commencing any work.(See Figure 4)
NOTE
There will be two types of appearance on the tail light connector. The product
is only compatible with TYPE “A”.
If your truck has TYPE “B”, please remove the excess plastic on the wire
harness plug we provided, this will help you in the following installation.
(See below for details)
- Next, grab the Redline Quick Connect Expansion Adapter Harness and Plug it into the vehicle’s OEM wiring harness. Plug the other end into the tail light connector (See Figure 5).
Route the Redline Quick Connect Expansion Adapter Harness from the left tail light opening to the right tail light opening, then repeat the same steps for the other side.
- Use some zip ties to secure the flat 4PIN trailer connector and reverse wire in place along the inner bumper.
- Finally, connect the available tailgate light bar to the 4PIN trailer connector and reverse wire for full functionality testing
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing
this product. The Installation Guide is intended as assistance to reduce setup
time. OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>