AURORA EN-ANT1224 LinearPac LED Light Instruction Manual

: June 11, 2024
: Aurora

Table of Contents

Installation Instructions
Installing Microwave Sensor Accessory: EN-ANTMS1
- Installing Emergency Pack / Emergency Self-Test Pack Accessory: EN-
MICROWAVE SENSOR
IMPORTANT INSTALLATION INFORMATION
EMERGENCY TESTING
- Emergency Installation and Inspection
- GUARANTEE
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AURORA EN-ANT1224 LinearPac LED Light

EN-ANT1224 LinearPac LED Light

Installation Instructions

Installing Microwave Sensor Accessory: EN-ANTMS1

Install MS Accessory Using the included plastic rivets
Reconnect Wires

See page 3 for MS Sensor Dip Switch settings

Installing Emergency Pack / Emergency Self-Test Pack Accessory: EN-

ANTEM1 / EN-ANTEMST1

Installing Emergency Pack / Emergency Self-Test Pack Accessory: EN-ANTEM1 /
EN-ANTEMST1

Install ME Pack Using the included plastic rivets
Open the case of the EM Pack and connect the battery plug
Reconnect Wires
Install LED indicator into the silicone ring
1 x LED for EN-ANTEM1
2 x LEDs for EN-ANTEMST1

See page 4 for Emergency LED indicator information

MICROWAVE SENSOR

Detection Area

Detection area can be reduced by selecting the combination on the DIP switches to fit precisely each application.

1

| 2|
---|---|---
ON| ON|

100%

–

| ON|

75%

ON

| –|

50%

–

| –|

25%

IMPORTANT INSTALLATION INFORMATION

Installation should be carried out by a qualified electrician in accordance with the latest edition of the National wiring regulations.
These luminaires are IP66 rated and are protected against multidirectional, high pressure water jets.
Maximum Input Voltage- 220-240V AC 50/60Hz
Ensure that ALL electrical connections are tight with no loose strands.
Before commencing installation or maintenance, ensure electricity is switched off at the mains.
Class I, mains voltage, this luminaire must be earthed.
This luminaire is not dimmable
Brown – (1) Live
Blue – (N) Neutral
Green/Yellow – Earth
Please Note: May not be compatible with PIR’s. Please contact sales office for compatibility.
We do not recommend mixing LEDs circuits with products such as extractor fans. This is due to the sensitive nature of LEDs and is not product specific.
This product contains a light source of energy efficiency class D.

SELF TEST METHOD: Please ensure this product is tested every Month (every 30 days, lasts for 10 seconds), and every Half-Year (every 180 days, lasts for 3 hours).

MODE

RESULT

---|---|---|---|---|---

Mains ON

Red LED. Loud Beep sound

No action needed

| LED fault| Amber (Flashes every 1 Hz) | Beep every 45 seconds *|

Amber LED. Loud Beep sound *

| | | | |

Monthly self test battery discharge (discharges the battery for 10 seconds)

| Monthly test mode:

Hold test button for 3 seconds. 2 beeps.

Red LED. Loud Beep sound

LED fault

| Amber (Flashes every 1 Hz)| Beep every 45 seconds|

Amber LED. Loud Beep sound

| | | | |

Half-Year self test battery discharge (discharges the battery for 3 hours)

Red LED. Loud Beep sound

LED fault

| Amber (Flashes every 1 Hz)| Beep every 45 seconds|

Amber LED. Loud Beep sound

| | | | |

Mains Failure

EMERGENCY TESTING

After connecting the mains supply check the following:

The green charge indicator LED is illuminated. This indicates that the mains supply is present and that the charger circuit is working correctly.
The unit should be left on charge for a minimum of 24 hours before testing the emergency mode.
To simulate normal mains supply failure, operate the key switch
The lamp will now light under emergency conditions.
When the unit no longer meets its rated duration of operation the battery pack must be replaced with a battery of the same type, voltage and Amp-hour rating.

Emergency Installation and Inspection

Installation/ Test Record

| Serial/ Luminaire Number:|
---|---|---
Installed By:| | Date:|
Commissioned By:| | Date:|

| Year 1| Year 2| Year 3| Year 4**
The battery must be replaced
---|---|---|---|---
Monthly test| Signed| Date| Signed| Date| Signed| Date| Signed**|

Date

1

| | | | | | | |

2

| | | | | | | |

3

| | | | | | | |

4

| | | | | | | |

5

| | | | | | | |

6

| | | | | | | |

7

| | | | | | | |

8

| | | | | | | |

9

| | | | | | | |

10

| | | | | | | |

11

| | | | | | | |

12

| | | | | | | |

Environmental Protection (W.E.E.E.)-Aurora’s WEEE Reg. No. WEEIBG0130YX (UK Only)

Waste Electrical & Electronic Equipment Regulations (WEEE) requires that any of our products showing this marking (left) must not be disposed of with other household or commercial waste. Aurora does not levy any WEEE disposal charges to its customers for affected WEEE related products.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate any such product from other waste types and recycle it responsibly at your local facilities. Check with your Local Authority, Recycling Centre or retailer for recycling advice. If, when you purchased any Aurora product, your supplier included a WEEE disposal fee, you should then contact your supplier for advice on his take back of the product for the correct disposal.

GUARANTEE

This luminaire is guaranteed for a period of 5 years from the date of purchase. The emergency battery is guaranteed for a period of 3 years from the date of purchase. The guarantee is invalid in the case of improper use, installation, tampering, and removal of the a.c. date label, installation in an improper working environment or installation not according to the current edition of the National Wiring Regulations. Should this product fail during the guarantee period it will be replaced free of charge, subject to correct installation and return of the faulty unit. Aurora does not accept responsibility for any installation costs associated with the replacement of this product. This warranty is in addition to the statutory rights in your country of purchase. Aurora reserves the right to alter specifications without prior notice.