STEALTH 600 Gen 2 USB Wireless Headset User Guide
- October 27, 2023
- STEALTH
Table of Contents
STEALTH 600 Gen 2 USB Wireless Headset
IMPORTANT
PLEASE MAKE SURE YOUR HEADSET IS UPDATED WITH THE LATEST FIRMWARE.
Connect to the Turtle Beach Audio Hub for Windows or Mac to update the firmware. turtlebeach.com/audiohub.
CONTENTS
CHARGING
The Stealth 600 Gen 2 USB gives you 24+ hours of rechargeable battery life. Make sure to charge it regularly before storing it.
Headset Storage
Always charge your headset before storing it for any extended period of time
greater than 3 months). Never store the unit in temperatures above 113°F/45°C.
HEADSET CONTROLS
SUPERHUMAN HEARING
Microphone Mute
Flip up mic to mute. There is an audible tone when the mic is muted or
unmuted.
Use Superhuman Hearing Mode to ppinpoint quiet audio cues like enemy
ffootsteps and weapon reloads. During gameplay, you can activate and
ddeactivate Superhuman Hearing by ppressing the POWER button once, quickly
.
- EQ PRESETS
- Signature Sound
- Bass Boost
- Bau + Treble Boost
- Vocal Boost
LED BEHAVIORS
- HEADSET LED MEANING
- Solid Green Head and Transmitter Paired
- Breathing Green (While Charging & an) B1Hery Full
- LED turns off when the battery is fully charged if the headset is off.
- Double-link Green Not Paired
- Solid Red (While Charging) Battery Charging
- Bruins Red Battery Low
- LED turns off when the battery is fully charged if the headset is off.
- LED turns off when the battery is fully charged if the headset is off.
- TRANSMITTER-LED INDICATION: MEANINGG
- Solid Green Headset and Transmitter Paired
- Double-Blink Green Not Paired
- Breathing Red Mic Muted
SETUP FOR XBOX
- Connect the transmitter to the USB port.
- Power on the headset.
- Wait for the headset & transmitter to pair.
SURROUND SOUND FOR XBOX ONLY AVAILABLE ON XBOX)
- Go to Settings» General Volume & Audio Output
- Set Headset Format to Windows Sonic for Headphones
For updated setup instructions visit: turtlebeach.com/sonic.
RE-PAIRING
- From OFF, press and hold the POWER button on the headset until the LED starts flashing rapidly.
- Insert the transmitter into the console.
- Press and hold the pin-hole button on the side of the transmitter until the LED starts flashing rapidly.
- After a few moments, the headset and transmitter LEDs will become solid, indicating a successful pairing.
Regulatory Compliance Statements for the EAR FORCE Stealth” 600X Gen 2
USB
Models:
Stealth600X-USB-RX & Stealth600X-USB-TX
Local Restrictions on Radio Usage
Caution:
Due to the fact that the frequencies used by wireless devices may not yet be
harmonized in all countries, these radio products are designed for used only
in specific countries, and are not allowed to be operated in countries other
than those of designated use. As a user of tthese products, you are
responsible for ensuring that the products are used only in the countries for
which they were intended and for verifying that they are configured with the
correct selection of frequency and channel for the country of use. Any
deviation from the ppermissible power and frequency settings for the country
of use is an infringement of national law and may be punished as such.
To determine whether you are allowed to use your wireless network device in a specific country, please check to see if the radio type number that is printed on the identification label of your device is listed in the manufacturer’s OEM Regulatory Guidance document at the following http://www.turtlebeach.com/homologation or contact Turtle Beach directly.
Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the Stealth600X-USB-RX
& Stealthć00X-USB-TX:
- FCC ID: XGB-2372-RX & XGB-2372-TX
- RF Radiation Exposure & Hazard Warning
- Class B Interference Statement
- Non-Modification Statement
Class BInterference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These imats are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful iinterference to radio communications.
However, there is no guarantee that interference will not occur ina particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
or the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: [1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statement
To ensure compliance with FCC RF exposure requirements, this device must be
installed in a location such that the antenna of the device will be greater
than 2 cm l0.8 in.J from all persons. Using higher gain antennas and types of
antennas not covered under the FCC certification of this product is not
allowed. Installers of the radio and end users of the product must adhere to
the installation instructions provided in this manual. This transmitter must
not be co-located or operated in conjunction ith any other antenna or
transmitter.
Non-Modification Statement
Use only the supplied internal antenna. Unauthorized antennas, modifications,
or attachments could damage the Stealth600x-USB-RX & Stealth600X-USB-TXand
violate FCC regulations. Any changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to
operate this equipment. Please contact Turtle Beach for a list of approved 2.4
GHz antennas. This product is compliant with the Consumer Product Safety
Improvement Act of 2008, Public Law 110-314 (CPSIA).
Canadian ICES Statements
IC: 3879A-2372-RX & 3879A-2372-TX (Stealth600X-USB-RX & Stealth600X-USB-
TXI
This device complies with ICES-003 and RSS-247 of Industry Canada. Operation
is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Radiation Exposure & Hazard Statement
To ensure compliance with RSS-102 RF exposure requirements, this device must
be installed in a location such that the antenna of the device will be greater
than 2 cm (0.8 in.J away from all persons.. Using higher gain antennas and
types of antennas not covered under the |C certification of this product is
not allowed. Installers of the radio and end users of the product must adhere
to the installation instructions provided in this manual. Ihis transmitter
must not be co-located or operated in conjunction with any other antenna or
transmitter.
European Union and European Fair Trade Association Regulatory Compliance
This equipment may be operated in the countries that comprise the member
countries of the European Union and the European Fair Trade Association. These
countries, listed below, are referred to as The European Community throughout
this document:
AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE, GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA, LITHUANIA, LUXEMBOURG, MALTA, NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND.
Declaration of Conformity
Marking by this symbol:
Indicates compliance with the Essential Requirements of the Radio Equipment
Directive [RED) of the European Union [2014/53/EU).
This equipment meets the following conformance standards:
Safety:
- EN 62368-1: 2014+ A11 (T-Mark License),
- IEC 62368-1: 2014 (CB Scheme Certificate),
- EN 50332-1: 2013, EN 50332-2: 2013, EN 71-3: 2013
- Additional licenses issued for specific countries available on request
EMC:
- EN 55032: 2015, CISPR 32: 2015,
- EN 301 489-1 V2.1.1 (2017-02), EN 301 489-17 v3.1.1 (2016-11)
- EN 61000-h-2: 2009, EN 61000-4-3: 2006 + A1: 2008 + A2: 2010,
- EN 61000-4-8: 2010
The products are licensed, as required, for additional country-specific standards for the International Marketplace. Additional issued licenses are available upon request.
- Radio: EN 300 328v2.1.2 (2019-07
- SAR: EN 62311: 2008
Environmental:
RoHS 2015/863 amending Annex Ii to 2011/65/EU, WEEE 2012/19/Eu, REACH
2006/1907/EC, Packaging 94/62/EC, Battery 2006/66/EC, Toys Safety Directive
2009/48/EC
Please visit the following URL for a complete copy of the Declaration of
Conformity:
http://www.turtlebeach.com/homologation
Warning! This is a Class B product. In a domestic environment, this product
may cause radio interference, in which case, the user may be required to take
appropriate measures.
This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste. Instead, it Is your responsibility to dispose or your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. For more information about where you can drop off your waste or recycling, please contact your local authority, or where you purchased your product.
Turtle Beach Europe Ltd is obligated as a producer with the main activity of selling under The Producer Responsibility Obligations packaging Wastel Regulations 2007. To fulfill our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols, and the waste hierarchy principles of reduce, reuse, and recycle. https://www.complydirect.com/the- recycling-room/.
To access the rating label:
- Remove the left ear pad by pulling the ear pad straight up using your thumb.
- Once you’ve released the cloth from the lip on top, pull the ar pad straight back and it should slip right off.
To replace the ear pad, follow the same process in reverse.
Not seeing what you’re looking for here?
Visit turtlebeach.com/support for the latest
Tech Support information.
PAK DESIGN DEPT
COMMENTS
Please do not print this layer!!
- 100% actual size
- Refer to the video on how to fold
SPECIFICATIONS
- Printing information
- BLK+WHT
- QSG Paper Weight l80g Foldout
CHANGES
- Orig Arena #: 426-235-005-005
- New Arena #: 426-235-005-005 R01 (<brent Oliver)
- Date/ Initiator: 11/29/21/CREATIVE
PVT
- New Arena #: 426-235-005-005 RA (<taylor swanson)
- Date/ Initiator: 12/14/21/ CREATIVE
1. Updated Regulatory per Ziflow / Mickey S.
2. MP- New Arena #: AP# did not change l<gina opalec
- Date/Initiator: 12-16-21/PgM
1. Updated Regulatory per TimRead User Manual Online (PDF format)
Read User Manual Online (PDF format) >>