TORO 3454-491 GrandStand Revolution Mower Instruction Manual

TORO 3454-491 GrandStand Revolution Mower

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.

customer (all machines).
5| Operator’s Manual| 1|
Registration card| 1| Deliver the machine to the customer.
Key| 2|

Checking the Tire Pressure

No Parts Required

Procedure
Maintain the air pressure in the rear tires at 83 to 97 kPa (12 to 14 psi).
Important: Uneven tire pressure can cause an uneven cut.
Note: The front tires are semi-pneumatic tires and do not require air- pressure maintenance.

Checking the Grass Deflector

Procedure

DANGER

An uncovered discharge opening allows objects to be thrown toward you or bystanders. Also, contact with the blade could occur. Thrown objects or blade contact will cause serious injury or death. Do not operate the mower with the discharge deflector raised, removed, or altered unless a grass collection system or mulch kit is in place and working properly.

1. If there are plastic ties holding the grass deflector up, remove them and lower the deflector into the operating position.
2. Ensure that 1 end of the spring is installed behind the deck edge and the other end is installed around the grass deflector as shown in Figure 2.
   Important: The grass deflector must be free to rotate with downward tension. Lift the deflector up to the fully open position and ensure that it rotates freely, without binding into the fully down position.

Charging the Batteries

Parts needed for this procedure:

Procedure
Charge the batteries per the instructions in the Operator’s Manual for the machine.

Checking the Machine Before Delivery to the Customer (all machines)

Procedure
Before delivering the machine to the customer, ensure that you perform or have performed the procedures listed in the following table and initial each when finished. Refer to the Operator’s Manual for instructions on performing these procedures.

for the adjustment procedure.
 | Check the safety-interlock system; refer to the Operator’s Manual.
 | Ensure that the PTO works.
 | Check all fasteners that you installed to ensure that they are tight.

Delivering the Machine to the Customer

Parts needed for this procedure:

Procedure
At delivery, fill in the model and serial number, complete the items listed in the following table, and initial each when finished.

function:

•        Battery-disconnect switch

•        Transmission disengage

•        Battery-charger connector

•        InfoCenter

•        Key switch

•        Power-takeoff switch (PTO)

•        Motion-control levers

•        Mower height-of-cut

Refer to the Operator’s Manual to point out safety procedures, operation, and maintenance procedures.

 |
 |
 |
 |
 |
 |
 |
 |
 |
 |  | Review the warranty statement as shown in the Warranty.
 |  | Describe the post sale service procedures for your store.
 |  | Assist the customer in filling out and mailing the registration card or register online at www.Toro.com.
 |  | Make sure that the customer receives the Operator’s Manual and Setup Instructions.
 |  | Make sure that the customer knows the Parts Catalog and operator- training materials are available at www.Toro.com.
 |  | Assist the customer in loading the machine.

Note: When you, the dealer representative, have finished delivering the machine to the customer, sign and date in the space provided below and keep a copy of this page for dealer records. Also, the dealer must remind the customer to use a full-width trailer ramp to load the machine.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>