OPT7 Aura Interior Car Lights LED Strip Kit Instruction Manual

OPT7 Aura Interior Car Lights LED Strip Kit

AUX WIRING FOR DOOR/DOME LIGHT

There are two ways the AUX WIRE / Door Assist on the AURA control box can be connected on the vehicle in order to activate the door assists feature. Door assist allows you to choose the desire color choice upon selection on the “OPT7 CONNECT” app.

This feature will activate when the AUX wiring is connected to the positive and negative wiring of dome light or door light.
(*Please check the following wiring diagram before using this function to prevent incorrect installation)
NOTE: Trigger wire for door light is recommended if your dome light lights up progressively when opening door.

DISCLAIMER

OPT7 Lighting is not liable for damages or personal injuries while installing this product. The Installation Guide is intended as assistance to reduce setup time. OPT7 Lighting assumes no responsibility for improper installation.

If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7 Lighting will void product warranty

OPTION A (SINGLE AUX WIRE)

**FOR DOOR LIGHT WIRING

**

• On the driver side door, locate the door/courtesy light. Remove the plastic cover.
  

• Unplug the connect wire so you may locate the posive-guage trigger wire.
  

• Connect the AUX wire to the positive wire by twisting the metal wires together for the door light.
  

• Place the light back in.
  

• Done
  

FOR DOME LIGHT WIRING

• Remove the dome light plastic cover.
  

• Using a screwdriver, remove the two Phillips-head screws on the cover. Next, remove the dome light module, locate the power wires.
  

• Connect AUX wire to the positive wire on the Dome light.
  

• Place the light back in.
  

• Done
  

OPTION B (DOUBLE AUX WIRES)

FOR DOOR LIGHT WIRING

• On the driver side door, locate the door/courtesy light. Remove the plastic cover.
  

• Unplug the connect wire
  

• Connect positive AUX wire to the positive wire on the door light. Connect negative AUX wire to the negative wire on the door light.
  

• Place the light back in.
  

• Done
  

FOR DOME LIGHT WIRING

• Remove the dome light plastic cover.
  

• Using a screwdriver, remove the two Phillips-head screws on the cover. Next, remove the dome light module, locate the power wires.
  

• Connect positive AUX wire to the positive wire on the Dome light.
  Connect negative AUX wire to the negative wire on the Dome light.
  

• Place the light back in.
  

• Done
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>