AVARRO NX-FMM3763 Medium Full Motion Mount Instruction Manual
- June 9, 2024
- AVARRO
Table of Contents
MANUAL/MANUEL
MEDIUM FULL MOTION MOUNT
NX-FMM3763
Features:
- Fits 37-63″ up to 70lbs.
- VESA 100 x 100 to 400 x 400 (W x H) (mm)
- Locking mechanism secures rails to wall plate (pad lock optional)
- Tilts up to 10° to reduce glare
- Effortless tilting and swivel capability for more advanced viewing angles
- Low 1.97″ profile
- Post installation leveling
TOOLS NEEDED
SYMBOLS
HARDWARE PRODUCT NUMBERS
MONITOR PLATE AND ADAPTERS
Use diagrams to determine which mounting configuration is needed to attach
monitor plate (with or without adapters) to the back of TV. Please check TV
wall mounting compatibility before proceeding with installation.
Please ensure A and B adapters are positioned as shown in the below diagrams.
All measurements above: millimeters
PRODUCT COMPONENT PARTS
Contents| |
---|---|---
A| 1| Wall Plate
B| 1| Monitor Plate
CA| 2| Monitor Adapters A
CB| 2| Monitor Adapters B
D| 2| Wall Plate Covers
STEP 1-REMOVE MONITOR PLATE FROM MOUNT AND REMOVE COVERS FROM WALL PLATE
Remove monitor plate from wall plate
STEP 2-MONITOR PLATE ATTACHMENT
Connect monitor plate to TV
STEP 2B-IF NEEDED, ATTACH MONITOR ADAPTERS TO MONITOR PLATE(See page 3 for options)
Connect monitor plate with adapters to TV
STEP 2C-IF MORE CLEARANCE IS NEEDED (MONITOR PLATE)
Connect monitor plate to TV
Note: Steel washer only for M4 and M6 screws.
Spacers can also be used to provide clearance for cables and connectors
STEP 2D- USE M8 STEEL WASHER IF THE PHILLIPS SCREWS FROM THE MONITOR KIT ARE TOO LONG
Diagrams show two options for using additional washers if hardware screws are too long to properly tighten into back of flat panel television.
STEP 3A- WOOD STUD INSTALLATION (CONCRETE INSTALLATION SKIP TO STEP 3B)
Find stud and mark edge and center locations
WOOD DRILL BIT NOT INCLUDED
BROCA PARA MADERA NO INCLUIDA
STEP 3A- DRILL PILOT HOLE AND MOUNT WALL PLATE TO WALL
Mount wall plate
Drill Pilot Hole
STEP 3B – SOLID CONCRETE INSTALLATION
STEP 3B- DRILL PILOT HOLE AND MOUNT WALL PLATE TO WALL
STEP 4 – ATTACH PANEL TO MOUNT
Hang with TV attached
Heavy, Assistance Required
STEP 5 – ADJUST TILT TENSION/ POST INSTALLATION LEVEL
Secured Monitor Plate to Arm using 2 Phillips head screws. Tighten only to
snug tension.| TV can be leveled +/-3 degrees as needed. If security screws
are too tight it will be difficult to adjust leveling.| a) Rotate handle
clockwise
as far as possible.
b) Pull handle to side laterally (against spring tension) and rotate counter-
clockwise as far as possible.
c) Repeat steps a) and b) until TV holds desired tilt.
Limited Warranty
a. General
Subject to the terms and conditions of this Limited Warranty, from the date of
sale through the period of time for product categories specified in Section
1(b), ADI warrants AVARRO branded products to be free from defects in
materials and workmanship under normal use and service, normal wear and tear
excepted. Except as required by law, this Limited Warranty is only made to
Buyer and may not be transferred to any third party.
ADI shall have no obligation under this Limited Warranty or otherwise if:
(i) The product is improperly installed, applied or maintained;
(ii) The product is installed outside of stated operating parameters, altered,
or improperly services or repaired;
(iii) Damage is caused by outside natural occurrences, such as lightning,
power surges, fire, floods, acts of nature, or the like.
(iv) Defects resulting from unauthorized modification, misuse, vandalism, or
other causes
unrelated to defective materials or workmanship, or failures related to
batteries of any type used in connection with the products sold hereunder.
ADI only warrants those products branded AVARRO and sold by ADI. Any other
products branded by third parties are warranted by the third party
manufacturer for a period as defined by the third party manufacturer, and ADI
assigns to Buyer those warranties and only those warranties extended by such
third party manufacturers or vendors for non-ADI branded products. ADI does
not itself warrant any non-ADI branded product and sells only on an as is
basis in accordance with ADI’s terms and conditions of sale.
b. Specific Warranties for product categories are as follows:
Product Categories | Warranty Period |
---|---|
Mounts | 5 years |
Rack | 5 years |
2. EXCLUSION OF WARRANTIES, LIMITATION OF LIABILITY
THERE ARE NO WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. TO THE FULLEST EXTENT PERMITTED BY LAW, IN NO CASE SHALL ADI BE LIABLE TO ANYONE FOR ANY (I) CONSEQUENTIAL, INCIDENTAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES ARISING OUT OF OR RELATING IN ANY WAY TO THE PRODUCT AND.OR FOR BREACH OF THIS OR ANY OTHER WARRANTY OR CONDITION, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY ADI’S OWN NEGLIGENCE OR FAULT AND EVEN IF ADI HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH LOSSES OR DAMAGES. Any product description (whether in writing or made orally by ADI or ADI’s agents), specifications, samples, models, bulletin, drawings, diagrams, engineering sheets, or similar materials used in connection with the Buyer’s order are for the sole purpose of identifying ADI’s products and shall not be construed as an express warranty or condition. Any suggestions by ADI or ADI’s agents regarding use, applications or suitability of the products shall not be construed as an express warranty or condition unless confirmed to be such in writing by ADI. ADI does not represent that the products it sells may not be compromised or circumvented; that the products will prevent any personal injury or property loss by burglary, robbery, fire or otherwise, or that the products will in all cases provide adequate warning or protection. Buyer understands and will cause its customer to understand that a properly installed and maintained product is not insurance or guarantee that such will not cause or lead to personal injury or property loss. CONSEQUENTLY ADI SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON ANY CLAIM AT ALL INCLUDING A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING. However, if ADI is held liable whether directly or indirectly for any loss or damage with respect to the products it sells, regardless of cause or origin, its maximum liability shall not in any case exceed the purchase price of the product, which shall be fixed as liquidated damages and not as a penalty and shall be the complete and exclusive remedy against ADI.
3. Limitation on Liability to Buyer’s Customers.
Buyer agrees to limit liability to its customers to the fullest extent permitted by law. Buyer acknowledges that ADI shall only be deemed to give consumers of its products such statutory warranties as may be required by law and at no time shall Buyer represent to its customers and/or users of ADI products that ADI provides any additional warranties. By accepting the products, to the fullest extent permitted by law, Buyer assumes all liability for, and agrees to indemnity and hold ADI harmless against and defend ADI from, any and all suits, claims, demands, causes of action and judgments relating to damages, whether for personal injury or to personal property, suffered by any person, firm, corporation or business association, including but not limited to, Buyer’s customers and/or users of the products because of any failure of the products to detect and/or warn of the danger for which the goods were designed or any other failure of the products whether or not such damages are caused or contributed to by the sold or joint concurring negligence or fault of ADI.
4. Returns
Subject to the terms and conditions listed below, during the applicable
warranty period, ADI will replace Product or provide a credit at purchase at
its sole option free of charge any defective products returned prepaid. Any
obligations of ADI to replace Limited Lifetime warranty products pursuant to
this warranty which result from defect are limited to the availability of
replacement product. ADI reserves the right to replace any such product s with
the then currently available products, or provide a credit in its sole
discretion. In the event Buyer has a problem with any ADI product, please call
your local ADI branch for return instructions:
For US call 1-800-233-6261
For Canada call 877-234-7378
For Puerto Rico call 787-793-8830
Be sure to have the model number and the nature of the problem available. In
the event of replacement, the return product will be credited to Buyer’s
account and a new invoice issued for the replacement item. ADI reserves the
right to issue a credit only in lieu of replacement.
If any AVARRO branded products are found to be in good working order or such
product’s inability to function properly is a result of user damage or abuse,
the product will be returned to Buyer in the same condition as received and
Buyer shall be responsible for any return freight changes.
5. Governing Law
The laws of State of New York apply to this Limited Warranty.
6. Miscellaneous
Where any term of this Limited Warranty is prohibited by such laws, it shall
be null and void, but the remainder of the Limited Warranty shall remain in
full force and effect.
CAUTION: DO NOT EXCEED MAXI-MUM WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!Max Loading Weight: 70 lbs
For more information please call
1-833-574-9124 or email
AVARRO@adiglobal.com
To learn more about AVARRO products visit
avarro.adiglobaldistribution.us
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>