Steinbach 018255 Automatic pH Control Analog Instructions
- June 5, 2024
- Steinbach
Table of Contents
018255
Instructions
018255 Automatic pH Control Analog
Instructions when using 15% liquid Ph-Minus to increase the dosing rate and limit the dosing time
With the pH controller switched on, disconnect it from the mains and press and
hold the arrow key.
Plug the unit back in and only release the buttons when the number 05 appears
on the display. The LEDs “pH value upper limit”, “Dosing” and “Alarm” flash.
Display 05 is the dosing interval of 5 min.
Confirm with entering.
Now the LEDs “pH value lower limit”, “Dosing”, and “Alarm” flash and the display shows the set value for the pH value lower limit (preset 10). This is the percentage of the minutes in which the pump is active.
Increase the percentage to 20 with the up arrow key (1) and confirm by
entering (2).
Example: 5 min = 300 sec. of which 20% are 60 sec. i.e. the pump doses 60 sec.
and measures the effect of the acid for 4 min.
The display now shows 35 and the LEDs “Calibration”, “Dosing” and “Dosing” are
lit. “Alarm” flashes. This is the number of dosing intervals until the dosing
time limit L1 becomes active.
Confirm with entering.
Example: if the dosing interval is set to 5 min, then 12 intervals per
hour are possible, i.e. if the value is not reached after 3 hours, “L1”
appears on the display. This status is reset by switching the unit off and on
again.
The display now shows 04 and the LEDs “Dosage” and “Alarm” and one without a
label flash. Press the arrow key upwards to change this value.
(1) to 05 and confirm by entering (2). This is the number of L1 intervals
until the dosing time limit L2 becomes active, i.e. if the value is not
reached after 5 x 3 hours, L2 appears on the display and must be reset by the
user (see operating instructions).
ATTENTION: When changes are made, particularly at the dosing interval,
the running time of the filter pump2 may also have to be adjusted. be adapted.
Please do not hesitate to contact us if you have any questions.