AVARRO NX-TXL3790 Fixed X-Large TV Mount Instruction Manual
- June 9, 2024
- AVARRO
Table of Contents
- AVARRO NX-TXL3790 Fixed X-Large TV Mount
- Features
- TOOLS NEEDED
- SYMBOLS
- HARDWARE PRODUCT NUMBERS
- PRODUCT COMPONENT PARTS
- STEP 1A – FLAT BACK FLAT PANEL (VERTICAL RAILS)
- STEP 1B – CURVED BACK FLAT PANEL (VERTICAL RAILS)
- Limited Warranty
- EXCLUSION OF WARRANTIES, LIMITATION OF LIABILITY
- Limitation on Liability to Buyer’s Customers
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
AVARRO NX-TXL3790 Fixed X-Large TV Mount
Features
- Fits 37″- 90″ TVs up to 175 lbs.
- VESA 100 x 100 to 700 x 400 (W x H) (mm)
- Locking mechanism secures rails to wall plate (pad lock optional)
- Post installation leveling
CAUTION: DO NOT EXCEED MAXI-MUM WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR! Max Loading Weight: 175 lbs
TOOLS NEEDED
SYMBOLS
HARDWARE PRODUCT NUMBERS
PRODUCT COMPONENT PARTS
Flat Panel Mounting Pattern (W x H)
Minimum: 100mm x 100mm
Maximum: 700mm x 450mm
Contents
A| 1| Wall Plate
B| 2| Vertical Rails
C| 2| Locking Mechanism
D| 1| Pendant
15| 1| Bubble Level
STEP 1A – FLAT BACK FLAT PANEL (VERTICAL RAILS)
Connect Vertical Rails to flat panel
STEP 1B – CURVED BACK FLAT PANEL (VERTICAL RAILS)
Connect Vertical Rails to flat panel
Spacers can also be used to provide clearance for cables and connectors
STEP 1- USE M8 STEEL WASHER IF THE PHILLIPS SCREWS FROM THE MONITOR KIT
ARE TOO LONG
Diagrams show two options for using additional washers if hardware screws are
too long to properly tighten into back of flat panel television.
Select the proper spacers or spacer suit as below if necessary
STEP 2- WOOD STUD INSTALLATION (CONCRETE INSTALLATION SKIP TO STEP 3)
Find stud and mark edge and center locations
STEP 2A & 2B– LOCATE WOOD STUDS AND DRILL PILOT HOLES
Drill pilot hole
Mark center of wood using stud finder and pencil, use wall plate to level and
mark pilot holes.
Drill 4 pilot holes
STEP 2C- MOUNT WALL PLATE TO WALL
Mount wall plate
Works with 16” or 24” stud spacing.
STEP 3 – SOLID CONCRETE INSTALLATION
Use wall plate to mark mounting locations/ drill pilot holes
- Level
- Solid Concrete
- Drill Bit
- Drill Pilot Hole
STEP 3A & 3B – POSITION WALL PLATE, MARK, & DRILL PILOT HOLES
Position wall plate to desired location, level, and mark pilot locations with
pencil.
Drill 4 pilot holes
STEP 3C- SOLID CONCRETE INSTALLATION
Insert wall Anchors gently into concrete wall with hammer if necessary
STEP 4A- ATTACH PANELTO WALL PLATE & ADJUST TILT ANGLE
Hang vertical rails with monitor attached
STEP 4B- ADJUST THE SCREWS ON THE VERTICAILS TO LEVEL THE FLAT PANEL
Maximum leveling adjustment 0.5”
STEP 4C- ADDITIONAL SECURITY FEATURE (OPTIONAL)
Vertical Rails have 7mm hole located at the bottom for placement of pad lock for additional theft) security (pad lock not included)
STEP 4D – ADJUST STRAP LENGTH (OPTIONAL)
Limited Warranty
General
Subject to the terms and conditions of this Limited Warranty, from the date of sale through the period of time for product categories specified in Section 1(b), ADI warrants AVARRO branded products to be free from defects in materials and workmanship under normal use and service, normal wear and tear excepted. Except as required by law, this Limited Warranty is only made to Buyer and may not be transferred to any third party.
ADI shall have no obligation under this Limited Warranty or otherwise if:
- The product is improperly installed, applied or maintained;
- The product is installed outside of stated operating parameters, altered, or improperly services or repaired;
- Damage is caused by outside natural occurrences, such as lightning, power surges, fire, floods, acts of nature, or the like.
- Defects resulting from unauthorized modification, misuse, vandalism, or other causes unrelated to defective materials or workmanship, or failures related to batteries of any type used in connection with the products sold hereunder.
ADI only warrants those products branded AVARRO and sold by ADI. Any other products branded by third parties are warranted by the third party manufacturer for a period as defined by the third party manufacturer, and ADI assigns to Buyer those warranties and only those warranties extended by such third party manufacturers or vendors for non-ADI branded products. ADI does not itself warrant any non-ADI branded product and sells only on an as is basis in accordance with ADI’s terms and conditions of sale.
Specific Warranties for product categories are as follows
Product Categories | Warranty Period |
---|---|
Mounts | 5 years |
Rack | 5 years |
EXCLUSION OF WARRANTIES, LIMITATION OF LIABILITY
THERE ARE NO WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. TO THE FULLEST EXTENT PERMITTED BY LAW, IN NO CASE SHALL ADI BE LIABLE TO ANYONE FOR ANY (I) CONSEQUENTIAL, INCIDENTAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES ARISING OUT OF OR RELATING IN ANY WAY TO THE PRODUCT AND.OR FOR BREACH OF THIS OR ANY OTHER WARRANTY OR CONDITION, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY ADI’S OWN NEGLIGENCE OR FAULT AND EVEN IF ADI HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH LOSSES OR DAMAGES. Any product description (whether in writing or made orally by ADI or ADI’s agents), specifications, samples, models, bulletin, drawings, diagrams, engineering sheets, or similar materials used in connection with the Buyer’s order are for the sole purpose of identifying ADI’s products and shall not be construed as an express warranty or condition. Any suggestions by ADI or ADI’s agents regarding use, applications or suitability of the products shall not be construed as an express warranty or condition unless confirmed to be such in writing by ADI. ADI does not represent that the products it sells may not be compromised or circumvented; that the products will prevent any personal injury or property loss by burglary, robbery, fire or otherwise, or that the products will in all cases provide adequate warning or protection. Buyer understands and will cause its customer to understand that a properly installed and maintained product is not insurance or guarantee that such will not cause or lead to personal injury or property loss. CONSEQUENTLY ADI SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON ANY CLAIM AT ALL INCLUDING A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING. However, if ADI is held liable whether directly or indirectly for any loss or damage with respect to the products it sells, regardless of cause or origin, its maximum liability shall not in any case exceed the purchase price of the product, which shall be fixed as liquidated damages and not as a penalty and shall be the complete and exclusive remedy against ADI.
Limitation on Liability to Buyer’s Customers
Buyer agrees to limit liability to its customers to the fullest extent permitted by law. Buyer acknowledges that ADI shall only be deemed to give consumers of its products such statutory warranties as may be required by law and at no time shall Buyer represent to its customers and/or users of ADI products that ADI provides any additional warranties. By accepting the products, to the fullest extent permitted by law, Buyer assumes all liability for, and agrees to indemnity and hold ADI harmless against and defend ADI from, any and all suits, claims, demands, causes of action and judgments relating to damages, whether for personal injury or to personal property, suffered by any person, firm, corporation or business association, including but not limited to, Buyer’s customers and/or users of the products because of any failure of the products to detect and/or warn of the danger for which the goods were designed or any other failure of the products whether or not such damages are caused or contributed to by the sold or joint concurring negligence or fault of ADI.
Returns
Subject to the terms and conditions listed below, during the applicable
warranty period, ADI will replace Product or provide a credit at purchase at
its sole option free of charge any defective products returned prepaid. Any
obligations of ADI to replace Limited Lifetime warranty products pursuant to
this warranty which result from defect are limited to the availability of
replacement product. ADI reserves the right to replace any such products with
the then currently available products, or provide a credit in its sole
discretion. In the event Buyer has a problem with any ADI product, please call
your local ADI branch for return instructions:
- For US call 1-800-233-6261
- For Canada call 877-234-7378
- For Puerto Rico call 787-793-8830
Be sure to have the model number and the nature of the problem available. In
the event of replacement, the return product will be credited to Buyer’s
account and a new invoice issued for the replacement item. ADI reserves the
right to issue a credit only in lieu of replacement.
If any AVARRO branded products are found to be in good working order or such
product’s inability to function properly is a result of user damage or abuse,
the product will be returned to Buyer in the same condition as received and
Buyer shall be responsible for any return freight changes.
Governing Law
The laws of State of New York apply to this Limited Warranty.
Miscellaneous
Where any term of this Limited Warranty is prohibited by such laws, it shall
be null and void, but the remainder of the Limited Warranty shall remain in
full force and effect.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>