AVARRO 0E-HDMISW3X1 Hdmi Switcher 3 Inputs X 1 Output User Manual

: June 8, 2024
: AVARRO

Table of Contents

Introduction
Features
Package Contents
Panel
Specification
Wiring
IR Remote Handset
Troubleshooting
Limited Warranty
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

AVARRO 0E-HDMISW3X1 Hdmi Switcher 3 Inputs X 1 Output User Manual

Introduction

Overview
0E-HDMISW3X1 is a 3 by 1 4K HDMI with HDCP 2.2 switcher which supports resolutions up to 4K@60Hz 4:2:0 8bit, a perfect solution for managing multiple sources.
It provides three inputs for direct connection of HDMI devices, which gives you a high-performance connection between three sources and a display without signal loss.
A desired HDMI source can be easily selected for the display from the panel switch button or using the supplied IR remote. The front panel LEDs show the currently selected source.

Features

Easy to use, install in seconds.
Supports up to 4K@60 Hz 4:2:0 8bit.
HDCP 2.2 compliant.
Supports HDMI transmission distance up to 3 meters at 4K@60Hz 4:2:0 8bit.
Supports HDMI source devices for power supplying.
Supports remote control and front panel button control.

Note: In order to ensure proper functionality, make sure the resolution of the sink is set to 4K@60Hz 4:2:0 or less when both the connected sources and sink support 4K@60Hz 4:4:4 8 bit.

Package Contents

Before you start the installation of the product, please check the package contents:

1 x 0E-HDMISW3X1
1 x IR Remote
1 x IR Receiver Cable
2 x Mounting Brackets
1 x User Manual

Panel

Front Panel

ID.	Name	Description
1	IR IN	Receiving IR signal.

Rear Panel

ID.	Name	Description
1	HDMI IN (1-3)	Connect to HDMI sources.
2	HDMI OUT	Connect to an HDMI display
3	IR EXT.	Connect to the supplied IR Receiver cable, for controlling the

switcher.

Specification

Technical

Input/output Signal Type| HDMI1.4 with HDCP 2.2

Input/output Resolution

Supported

| VESA:

800×6008, 1024×7688, 1280×7688,1280×8008,

1280×9608, 1280×10248,1360×7688, 1366×7688,

1400×10508, 1440×9008, 1600×9008,

1600×12008,1680×10508, 1920×12008

SMPTE:
1280x720P1,2,3,4,5,6,7,8, 1920x1080I6,8,
1920x1080P1,2,3,4,5,6,7,8,
3840×21602,3,5,6,8, 4096×21602,3,5,6,8;
1 = at 23.98 Hz, 2 = at 24 Hz, 3 = at 25 Hz,
4 = at 29.97 Hz, 5 = at 30 Hz, 6 = at 50 Hz,
7 = at 59.94 Hz, 8 = at 60 Hz

NOTE:
4096×2160/3840×2160@50Hz/60Hz is based
on chroma sub-sampling 4:2:0 8-bit only.

Control Method| IR remote control, Panel SWITCH button
General

Wiring

Connect HDMI source devices to the HDMI input ports via HDMI cables.
Connect an HDMI display to the HDMI output port via an HDMI cable.
Connect the IR receiver cable to the IR EXT port if you need to extend the control distance.
Power on all the devices. Now you can use the panel SWITCH button or the included remote to control the switcher

Note: When you use the IR extend, the IR IN window on the other panel will be disabled.
Wiring

IR Remote Handset

The included remote control can be used to switch three HDMI sources to one display device.
Note: Please make sure that the remote is pointed directly at the IR receive window or IR receiver cable head.

Remote Handset

Troubleshooting

Most problems that occur are due to simple issues. If you have trouble, please check the list of simple fixes below.

Five Steps of Regular Troubleshooting Routine

Power: Make sure all devices are powered on. (source, switcher, display devices)
Indicator: Make sure LED indicators of switcher are normal according to user manual.
Devices: Make sure picture can be shown normally when connecting source to display devices directly.
Cable: Plug in and out HDMI cable or change another HDMI cable. For 4K@60Hz, HDMI cable should be less than 3m and standard HDMI cable is needed.
Compatibility: Please test other source and display devices to determine whether it is a compatibility issue.

Typical questions

How to deal with video flash or cut off during the installation?
- Verify that all the indicators are solid on. If not, please check if the power adapter or HDMI cables are well connected.
- Verify that the display device work properly and that the source devices have normal signals output.
How to deal with a weak or not working IR signal?
- Make sure the IR cable is correctly installed according to the diagram above.
- Pay attention to the control angle and distance as below: The control signal will be better when your controller is pointed at
  the IR receiver head directly.

Using the IR IN window on switcher panel:

Enabled Angle	0°	30°(Horizontal)	15°(Vertical)
Distance	9m(Max)	5m(Max)	4m(Max)

Using the IR extend receiver cable:

Enabled Angle	0°	30°(Horizontal)	15°(Vertical)
Distance	8m(Max)	4.5m(Max)	3m(Max)

Limited Warranty

Limited Warranty

a. General
Subject to the terms and conditions of this Limited Warranty, from the date of sale through the period of time for product categories specified in Section 1(b), ADI warrants AVARRO branded products to be free from defects in materials and workmanship under normal use and service, normal wear and tear excepted.
Except as required by law, this Limited Warranty is only made to Buyer and may not be transferred to any third party.
ADI shall have no obligation under this Limited Warranty or otherwise if:

1. The product is improperly installed, applied or maintained;
2. The product is installed outside of stated operating parameters, altered, or improperly services or repaired;
3. Damage is caused by outside natural occurrences, such as lightning, power surges, fire, floods, acts of nature, or the like.
4. Defects resulting from unauthorized modification, misuse, vandalism, or other causes unrelated to defective materials or workmanship, or failures related to batteries of any type used in connection with the products sold hereunder.

ADI only warrants those products branded AVARRO and sold by ADI. Any other products branded by third parties are warranted by the third-party manufacturer for a period as defined by the third-party manufacturer, and ADI assigns to Buyer those warranties and only those warranties extended by such third-party manufacturers or vendors for non-ADI branded products. ADI does not itself warrant any non-ADI branded product and sells only on an as is basis in accordance with ADI’s terms and conditions of sale.
b. Specific Warranties for product categories are as follows:
** Product Categories| Warranty Period**
---|---
HDMI Distribution| 2 years

EXCLUSION OF WARRANTIES, LIMITATION OF LIABILITY
THERE ARE NO WARRANTIES OR CONDITIONS, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. TO THE FULLEST EXTENT PERMITTED BY LAW, IN NO CASE SHALL ADI BE LIABLE TO ANYONE FOR ANY (I) CONSEQUENTIAL, INCIDENTAL, INDIRECT, SPECIAL, OR PUNITIVE DAMAGES ARISING OUT OF OR RELATING IN ANY WAY TO THE PRODUCT AND.OR FOR BREACH OF THIS OR ANY OTHER WARRANTY OR CONDITION, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY ADI’S OWN NEGLIGENCE OR FAULT AND EVEN IF ADI HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH LOSSES OR DAMAGES.

Any product description (whether in writing or made orally by ADI or ADI’s agents), specifications, samples, models, bulletin, drawings, diagrams, engineering sheets, or similar materials used in connection with the Buyer’s
order are for the sole purpose of identifying ADI’s products and shall not be construed as an express warranty or condition. Any suggestions by ADI or ADI’s agents regarding use, applications or suitability of the products shall not be construed as an express warranty or condition unless confirmed to be such in writing by ADI. ADI does not represent that the products it sells may not be compromised or circumvented; that the products will prevent any personal injury or property loss by burglary, robbery, fire or otherwise, or that the products will in all cases provide adequate warning or protection. Buyer understands and will cause its customer to understand that a properly installed and maintained product is not insurance or guarantee that such will not cause or lead to personal injury or property loss.

CONSEQUENTLY, ADI SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER LOSS BASED ON ANY CLAIM AT ALL INCLUDING A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING.

However, if ADI is held liable whether directly or indirectly for any loss or damage with respect to the products it sells, regardless of cause or origin, its maximum liability shall not in any case exceed the purchase price of
the product, which shall be fixed as liquidated damages and not as a penalty and shall be the complete and exclusive remedy against ADI.

Limitation on Liability to Buyer’s Customers.
Buyer agrees to limit liability to its customers to the fullest extent permitted by law. Buyer acknowledges that ADI shall only be deemed to give consumers of its products such statutory warranties as may be required by law and at no time shall Buyer represent to its customers and/or users of ADI products that ADI provides any additional warranties. By accepting the products, to the fullest extent permitted by law, Buyer assumes all liability for, and agrees to indemnity and hold ADI harmless against and defend ADI from, any and all suits, claims, demands, causes of action and judgments relating to damages, whether for personal injury or to personal property, suffered by any person, firm, corporation or business association, including but not limited to, Buyer’s customers and/or users of the products because of any failure of the products to detect and/or warn of the danger for which the goods were designed or any other failure of the products whether or not such damages are caused or contributed to by the sold or joint concurring negligence or fault of ADI.

Returns
Subject to the terms and conditions listed below, during the applicable warranty period, ADI will replace Product or provide a credit at purchase at its sole option free of charge any defective products returned prepaid. Any obligations of ADI to replace Limited Lifetime warranty products pursuant to this warranty which result from defect are limited to the availability of replacement product. ADI reserves the right to replace any such products with the then currently available products, or provide a credit in its sole discretion. In the event Buyer has a problem with any ADI product, please call your local ADI branch for return instructions:

Be sure to have the model number and the nature of the problem available. In the event of replacement, the return product will be credited to Buyer’s account and a new invoice issued for the replacement item. ADI reserves the right to issue a credit only in lieu of replacement.
If any AVARRO branded products are found to be in good working order or such product’s inability to function properly is a result of user damage or abuse, the product will be returned to Buyer in the same condition as received and Buyer shall be responsible for any return freight changes.

Governing Law
The laws of State of New York apply to this Limited Warranty.

Miscellaneous
Where any term of this Limited Warranty is prohibited by such laws, it shall be null and void, but the remainder of the Limited Warranty shall remain in full force and effect.