SEGWAY GT Kick Scooter User Manual

June 9, 2024
Segway

SEGWAY GT Kick Scooter SEGWAY-GT-Kick-Scooter-
productDiagram and Functions

Handlebar FunctionsSEGWAY-GT-Kick-Scooter-
fig-9 Dashboard

Speed Modes IntroductionSEGWAY-GT-Kick-Scooter-
fig-10

Damper Adjustment

S (Slow rebound): Increase rebound resistance by rotating the Adjustment Knob clockwise.
F (Fast rebound):
Decrease rebound resistance by rotating the Adjustment Knob counterclockwise.
Note:
The damper is set to the default position before leaving the factory. Please follow the steps above to adjust it according to your riding habits.

Specifications

Item Parameter



Product

| Name| Segway SuperScooter GT1| Segway SuperScooter GT2
Model| GT1P| GT2P
Length × Width × Height| Approx. 58.5 × 25.8 × 51.5 in (1485 × 656 × 1308 mm)
Folded: Length × Width × Height| Approx. 58.5 × 25.8 × 33.9 in (1485 × 656 × 860 mm)
Net Weight| Approx. 47.6 kg (105 lbs)| Approx. 52.6 kg (116 lbs)



Rider

| Max. Payload| 150 kg (331 lbs)
Recommended Age| 14–60 years old
Required Height| 3’11”–6’6”(120–200 cm)









Machine

| Wheelbase| 45.2 in (1147 mm)
Ground Clearance| 5.5 in (140 mm)
Drive System| 1WD (One-wheel drive)| 2WD (Two-wheel drive)
Max. Speed[1]| Approx. 37.3 mph (60 km/h)| Approx. 43.5 mph (70 km/h )
Theoretical Range[2]| Approx. 43.5 miles (70 km)| Approx. 55.9 miles (90 km)
Typical Range[3]| Approx. 31.1 miles (50 km)| Approx. 37.3 miles (60 km)
Max. Slope| Approx. 23%| Approx. 30%


Traversable Terrain

| Asphalt/flat pavement; obstacles < 1.2 in (3 cm); gaps < 1.2 in (3 cm)
Operating Temperature| -10 to 40°C (14 to 104°F)
Storage Temperature| -20 to 45°C (-4 to 113°F)
IP Rating| IPX4
Duration of Charging (single)[4]| Approx. 12 h| Approx. 16 h
Duration of Charging (dual)[4]| Approx. 6 h| Approx. 8 h





Battery

| Model| NDAF5020A| NDAF5030A
Nominal Voltage| 50.4 V
Max. Charging Voltage| 58.8 V
Nominal Energy| 1008 Wh| 1512 Wh
Nominal Capacity| 20 Ah| 30 Ah
Charging Ambient Temperature| 0 to 40°C (32 to 104°F )
Battery Management System| Over-heating, short circuit, over-current, over- discharge and over-charge protection


Motor

| Motor Type| Air-cooled hub motor
Nominal Power| 1.4 kW, 1400 W| 1.5 kW2, 1500 W2
Max. Power| 3 kW, 3000 W| 3 kW2, 3000 W2
 | Item| Parameter
---|---|---

Charger

| Model| NBW58D802D0D
Input Voltage| 100–240 V~
Max. Output Voltage| 58.8 V
Output Power| 0.1 kW, 115.6 W
Rated Output| 57.8 V 2.0 A

Tire

| Type| 11-inch Self-sealing tubeless tires
Tire Pressure| 32 psi
Material| Rubber

Others

| Speed Modes| WALK mode, PARK mode, ECO mode, SPORT mode and RACE mode

Suspension System

| Front and rear spring suspension
Front and rear adjustable damper
Brake System| Front & Rear disc brakes

  1. Warning: it is your legal duty to comply with your local traffic law and regulations when using this product. In the Unites States, in certain States, an electric kickscooter is not allowed to be used on a public road (i.e., “on-road” ), if its maximum speed capacity, weight and/or other features do not comply with the mandatory requirements imposed by law. With respect to maximum speed capacity restriction, certain States require that an electric kickscooters’ maximum speed capacity shall be capped at / limited to a specific miles per hour if it is for on-road use, and the cap / limit varies in different States. By way of examples, the States that impose such maximum speed capacity restrictions include New York, Florida, Arizona, New Jersey etc. In the event you intend to use this product on-road in a State that imposes such maximum speed capacity restriction, you MUST select a proper lower speed mode of this Product to assure that the product’s maximum speed capacity under such speed mode complies with the law. In the event the maximum speed capacity of the lowest speed mode of this product nevertheless exceeds the maximum speed capacity restriction imposed by a State for on-road use, you shall not use this product on-road in that State. Furthermore, a State may have other law regulating on-road use of this product, such as the maximum speed requirement and/or helmet requirement. In addition to State law, there may be further restrictions or prohibition on use of electric kickscooters by local law and/or regulations. For off-road use of this product, there may be other restrictions and/or limitations imposed by the property owner or others. The App of the product may provide additional useful information related to this matter.
    Disclaimer: this is not a legal opinion or legal advice. The information provided herein (including in the App) is for your convenience and information purpose only. It is not intended to cover every piece of law and/or regulation that may be applicable to this product. Segway and Ninebot explicitly hereby disclaim any and all warranty and/or representation, express or implied, related to completeness, accuracy, up-to-date of such information. Segway and/or Ninebot reserves the right but not obligation to correct, implement and/or update the information. You shall use the information at your own risk. It is your sole responsibility to learn and understand any and all the law and/or regulations, requirements, prohibitions, restrictions and/or limitation imposed by either law, government authority, court, private party or the others that may apply to your use of this product.

  2. Theoretical Range: tested while riding with a full battery, 75 kg (165 lbs) load, 25°C (77°F), at the speed of 12.4 mph (20 km/h) on
    the average on pavement.

  3. Typical Range: tested while riding with a full battery, 75 kg (165 lbs) load, 25°C (77°F), at the speed of 24.9 mph (40 km/h) on average
    on pavement.

  • Some of the factors that affect range include speed, number of starts and stops, ambient temperature, etc. 4. Single charging: rated input current up to 2 Amps when charging with single charger. Dual charging: rated input current up to 4 Amps when charging with two chargers specified by the manufacturer.

Common Failures and Solutions

Error code Possible causes Solution
0 Throttle abnormality

Please contact after-sales service or an authorized dealer.

1| Dashboard communication failure
2| Battery communication failure
3| Turn signals abnormality
4| Headlight abnormality
5| Water dectection in stem top
6| Over-voltage protection of motor controller

7

| Under-voltage protection of battery/motor controller|

Please try to charge the scooter.

8| High scooter temperature| Please try to apply heat dissipation for the scooter.
9| High battery temperature| Please try to apply heat dissipation for the scooter.
10| Low battery temperature| Please try to warm up the scooter.
11| High front-drive-wheel temperature| Please try to apply heat dissipation for the front-drive-wheel.
12| Front-drive-wheel stall| Please restart the scooter and try again.
13| Front-drive-wheel current sensor error| Please contact after-sales service or an authorized dealer.
14| Front-drive-wheel over-current| Please restart the scooter and try again.
15| Front-drive-wheel motor phase failure| Please contact after-sales service or an authorized dealer.
16| High rear-drive-wheel temperature| Please try to apply heat dissipation for the rear-drive wheel.
17| Rear-drive-wheel stall| Please restart the scooter and try again.
18| Rear-drive-wheel current sensor error| Please contact after-sales service or an authorized dealer.
19| Rear-drive-wheel over-current| Please restart the scooter and try again.
20| Rear-drive-wheel motor phase failure|

Please contact after-sales service or an authorized dealer.

21| Rear motor hall sensor error
22| Front motor hall sensor error

Certifications

This product is certified to ANSI/CAN/UL-2272.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL-2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Cet équipement est conforme aux limites d’exposition aux radiations de la IC définies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)

Trademark

Segway, Segway GT, Segway-Ninebot and the Rider Design are the trademarks of Segway Inc.; Android is the trademark of Google Inc., App Store is a service mark of Apple Inc. The respective owners reserve the rights of their trademarks and copyrights, etc. referred to in this manual.
We have attempted to include descriptions and instructions for all the functions of the SuperScooter at the time of printing. However, due to constant improvement of product features and changes of design, your SuperScooter may differ slightly from the one shown in this document. Scan the QR Code on the cover of this manual, or visit the Apple app Store (iOS) or the Google Play Store (Android) to download and install the Segway-Ninebot App. Please note that there are multiple Segway and Ninebot models with different functions, and some of the functions mentioned herein may not be applicable to your unit. The manufacturer reserves the right to change the design and functionality of the SuperScooter product and documentation without prior notice.
© 2022 Ninebot (Beijing) Tech Co. Ltd. All rights reserved.
(※The Segway-Ninebot App can support SuperScooter with built-in Bluetooth)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals