Commercial Electric 81545 ON-OFF Turn Knob Socket Installation Guide

Commercial Electric 81545 ON-OFF Turn Knob Socket Installation

Underwriters Knot Nudo de seguridad

• Tighten Aiustar
• Rated:
• 250W-250V
• Medium Base

Replace worn or broken sockets on a variety of light fictures in your

home. For use with #18 or Stranded Copper Wire Only.

WARNING

• lo avoid fire, shock, or death, unplug lamp or turn off pOwer at circuit breaker or fuse and testthat power is off before Wiring.
• If you are not sure about any part of these instructions, consult a qualified electrician.
• Do not remove cardboard pape liner from shell or interior of cap.
• Do not installamp holder if cardboard paper liner of shell or interior of cap is missing.
• Installation and/or use of a metal lamp holder without a cardboard paper liner in both shell and cap may cause electrical shock, personal injury, death, fire or property damage.

INSTRUCTIONS: Follow these instructions exactly to maintain the polarity

of a correctly wire system.

1. Turn off power supply before installation.
2. To disassemble shell from cap press where indicated on shell. Remove wires from interior mechanism, and loosen set screw (if any) on bushing of old cap. Unscrew cap from pipe while holding pipe to prevent it from turning.
3. Pass wire through bushing on new cap. Screw cap onto pipe, tighten set screw on cap bushing securely. Insulating disk must be in bo m of cap.
4. Tie underwirters knot in wires (see diagram). Puill knot tight.
5. Strip insulation to expose 1/2in to 5/8in of bare copper strands. Be careful not to damage wire strands or insulation beyond stripped length.
6. Twist copper strands of each wire tightly together. Loop wires clockwise 3/4 turn around terminal screws. Firmly tighten screws over wire loops. Connect white or ribbed wire (or with colortracer or with silver strands) to Silver terminal screw and remaining wire to brass terminal screw. Cut off any loose strands not secure under screw heads.
7. Slide metal shell (with insulating liner inside) over mechanism so Switch is seated in slot(s) on shell and push shell firmly into cap until it locks securely and evenly into position. To assure locking, push on metal shell only.
8. Plug in lamp or restore power. Lamp holder model ZE-309

Lamp holder model ZE-309 MODEL/MODELO 81545

MADE IN VIETNAM DISTRIBUTED BY: HOME DEPOT 2455 PACES FERRY RD., N.W. ATLANTA, GA 30339 HOMEDEPOT.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>