iSeneo PA228A Magnetic Wireless Charger Pad With Pasteable Case User Manual
- June 6, 2024
- iSeneo
Table of Contents
iSeneo PA228A Magnetic Wireless Charger Pad With Pasteable Case
Introduction
- The inner magnets in the wireless charger attach iPhone 12 firmly,
- The dala cable had been connec!Ed with the wtreles.s charger.
How to use
- Connected
- Chage with QC3.0 adapler for fast charge (QC3.0chargersol:jseparatEty).
- For Magnetic Devices
- Inner magnets click your phone automatically for wireless charging.
- For Other Devices
- Please aim at the center of the phone when charging.
- Strong Attachment
- Tear off the film to paste the wireless charger anywhere.
- For the fast and safe charge, using a Quick Charge 2.0or 3.0 Wall Charger is highly recommended. Other Chargers may not work well with this device.
Attentions
- Please keep the charger away from water or other liquids.
- Do not place the charger too close to any magnetic stripe or clip card (ID card, bank cards. etc.I to avoid magnetic failure.
- This item Is not to be used on any mobile device with metal plates, as It will cause extreme heat that may burn and /or damage the device.
- Fast charge via the plug and USB charging cable (both support QC2.0 or QC3.0).
- Usually we recommend that the thickness of phone case should be within 4mm(0.12 Inch).
- The standard temperature of wireless charger QI Is 55’C. but the temperature of our products should be controlled within 45’C, The charger will cut off current when abnormal heating occurs. Please contact us if any damage occurs.
- We recommend that you turn off the power consumption so’tware before charging to effectively prevent the phone from overheating. When the lemperature exceeds 45’C during charging, ii is no al for the charging speec to slow down.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>