Commercial Electric 82235 3-Way Brushed Nickel Turn Knob Lamp Socket Installation Guide
- June 9, 2024
- Commercial Electric
Table of Contents
Commercial Electric 82235 3-Way Brushed Nickel Turn Knob Lamp Socket
Replace worn or broken sockets on a variety of light fixtures in your home. For use with #18 or Stranded Copper Wire Only.
WARNING
- To avoid fire, shock, or death, unplug the lamp or turn off power at the circuit breaker or fuse and test that power is off before wiring.
- If you are not sure about any part of these instructions, consult a qualified electrician.
- Do not remove the cardboard paper liner from the shell or interior of the cap.
- Do not install a lamp holder if the cardboard paper liner of the shell or interior of the cap is missing.
- Installation and/or use of a metal lamp holder without a cardboard paper liner in both shell and cap may cause electrical shock, personal injury, death, fire or property damage.
INSTRUCTIONS
Follow these instructions exactly to maintain the polarity of a correct wire system.
- Turn off the power supply before installation.
- To disassemble the shell from the cap press where indicated on the shell. Remove wires from the interior mechanism, and loosen the set screw (if any) on the bushing of the old cap. Unscrew the cap from a pipe while holding the pipe to prevent it from turning.
- Pass the wire through the bushing on the new cap. Screw the cap onto the pipe, and tighten the set screw on the cap bushing securely. The insulating disk must be at the bottom of the cap.
- Tie the underwriter’s knot in wires (see diagram). Pull the knot tight.
- Strip insulation to expose 1/2″ to 5/8 n of bare copper strands. Be careful not to damage wire strands or insulation beyond stripped length.
- Twist copper strands of each wire tightly together. Loop wires clockwise 3/4 turn around terminal screws. Firmly tighten screws over wire loops. Connect white or ribbed wire (or with color tracer or with silver strands) to the silver terminal screw and the remaining wire to the brass terminal screw. Cut off any loose strands not secure under screw heads.
- Slide metal shell (with insulating liner inside) over mechanism so switch is seated in the slot(s) on the shell and push shell firmly into cap until it locks securely and evenly into position. To assure locking, push on metal shell only.
- Plug-in lamp or restore power.
Lamp holder model ZE-309-3 MODEUM0DEL0 82235
MADE IN VIETNAM
DISTRIBUTED BY:
HOME DEPOT 2455 PACES FERRY RD., N.W. ATLANTA, GA 30339
HOMEDEPOT.C0M.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>