KUZCO CH87932 Ceiling LED Chandelier Instruction Manual
- June 4, 2024
- KUZCO
Table of Contents
CH87932 Ceiling LED Chandelier
Instruction Manual
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
CAUTION: HEAVY FIXTURE, THE JUNCTION BOX NEEDS TO BE REINFORCED BEFORE
INSTALLATION. ALL MOUNTING SCREWS MUST SCREW INTO A MINIMUM OF 1” OF WOOD
BEHIND THE DRYWALL. DO NOT MOUNT THIS FIXTURE JUST TO DRYWALL.
- Remove the fixture from its original package
- Separate mounting plate (1c) from the canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package
- Secure mounting plate (1c) to the mounting surface with anchors (1f) and screws (1g)
- To change fixture height, push and hold the wire gripper (2g), slide the wire to the desired length and then release wire gripper (2g) to secure
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
- Fine tone wire length if necessary, by push and hold wire gripper (2g) and then adjust the wire to the desired length
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
20220520
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>