TRIDONIC PWM CV 4CH BasicDIM Wireless Installation Guide
- June 3, 2024
- TRIDONIC
Table of Contents
PWM CV 4CH BasicDIM Wireless
Installation Guide
PWM CV 4CH BasicDIM Wireless
Wiring diagram
solid
Antenna is located on the top of the device.
basicDIM Wireless PWM CV 4CH
The basicDIM Wireless PWM CV 4CH module is a four-channel PWM dimmer for constant voltage LED loads, such as LED strips and constant voltage LED modules, which can be controlled via Bluetooth. basicDIM Wireless PWM CV 4CH module is supplied with 12–24 V DC. The LED load is connected at the output.
Technical Data
DC voltage range (inputs/outputs) | 12–24 V |
---|---|
Max. input current | 6:00 AM |
Max. output current | 6:00 AM |
Output power | 144 W / 24 V DC, 72 W / 12 V DC |
Typ. power draw in stand-by | < 0.3 W |
Operating frequency radio receiver | 2.4–2.483 GHz |
Max. output power radio receiver | + 4 dBM |
Ambient temperature | -20… +45 °C |
tc point | 75°C |
Storage temperature | -25… +75°C |
Dimensions L x W x H | 72.6 x 30.0 x 18.0 mm |
Degree of protection | IP20 |
Safety instructions
- Installation of this device may only be carried out by specialist staff who have provided proof of their skills.
- The power supply must be switched off before handling the device.
- The relevant safety and accident prevention regulations must be observed.
article number/Artikelnummer: 28002575
Installation Instructions
Ensure that the mains voltage is switched off when you are establishing
connections. Use single or multiple-stranded cable with a cross-section of
0.75–1.5 mm².
Remove 6–7 mm of insulation at the end of the cable.
Insert the cables in the intended openings and tighten the screw terminal.
Ensure that the inputs and outputs are connected correctly.
The input terminals (Input) are labelled with the „+“ and „–“ icons, and the
output terminals (Output) are labelled with „+“ and „–(1)“, „–(2)“, „–(3)“,
„–(4)“.
Compatible devices
Compatible with all Android 4.4 (KitKat) or later, iPhone 4S (iOS 5.0) or
later and iPAD 3 (iOS 5.1) or later.
Hereby, Tridonic declares that the radio equipment type basicDIM Wireless PWM
CV 4CH is in compliance with Directive 2014/53/EU.
Hereby, Tridonic declares that the radio equipment type basicDIM Wireless PWM
CV 4CH is in compliance with Directive UK SI 2017 No. 1206.
The full text is available at the following internet address:
https://trid.help/en28002575cer
Areas of application
The device may only
- be used for the applications specified.
- for safe installation in dry, clean environment.
- be installed in such a way that access is only possible using a tool.
03/22-15013092-2 We reserve the right to make technical changes without prior
notice.
Tridonic GmbH & Co KG,
www.tridonic.com,
info@tridonic.com,
Tel. +43 5572 395-0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>