KUZCO PD82572 Ceiling LED Pendant Instruction Manual
- June 4, 2024
- KUZCO
Table of Contents
PD82572 Ceiling LED Pendant
Instruction Manual
Ceiling LED Pendant
PD82572
INSTALLATION SHEET
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
- Technical Support: 1-855-855-8926
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
- Remove fixture from its original package
- Separate mounting plate (1c) from the canopy (2a) by removing canopy screws (2f)
- Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in the hardware package
- Secure mounting plate (1c) to the mounting surface with anchors (1f) and screws (1g)
- Determine the hanging height of the fixture by securing rods (2d) to canopy (2a) and fixture (3a) after feeding fixture wires (LED+ and LED-) through rods
- Make proper electrical connections between LED and DC driver, LED- Negative, LED+ Positive using the quick connector provided (See Illustration 1 and refer to the diagram on the driver)
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package and place driver (4a) inside the canopy (2a)
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2f)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
20211015
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>