mXion SLIM Petroleum Imitation Module User Manual

: June 3, 2024
: mXion

Table of Contents

Introduction
General information
Summary of Funktions
Scope of supply
Hook-Up
Connectors
Product description
Technical data
Warranty, Service, Support
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

mXion SLIM Petroleum Imitation Module User Manual

Introduction

Dear customer, we strongly recommend that you read these manuals and the warning notes thouroughly before installing and operating your device. The device is not a toy (15+).

NOTE: Make sure that the outputs are set to appropriate value before hooking up any other device. We can’t be responsible For any damage if this is disregarded.

General information

We recommend studying this manual thoroughly before installing and operating your new device.
Place the decoder in a protected location. The unit must not be exposed to moisture.

NOTE: Some funktions are only available with the latest firmware.
Please make sure that your device is programmed with the latest firmware.

Summary of Funktions

DC/AC/DCC/PWM/ANALOG operation
Petroleum imitation modul usable.
Fluorescent imitation modul usable

Scope of supply

Manual
mXion SLIM
Light depend sensor

Hook-Up

Install your device in compliance with the connecting diagrams in this manual.
The device is protected against shorts and excessive loads. However, in case of a connection error e.g. a short this safety feature can’t work and the device will be destroyed subsequently.
Make sure that there is no short circuit caused by the mounting screws or metal.

Connectors

Switch output is switched to ground, use + pole as counter – connection for consumers.
Connectors

Product description

The mXion SLIM is a versatile module! It is used to simulate neon tubes (start flickers) and petroleum lamps. Tue to the small size of a fingernail this module can be installed in just about any vehicle can be installed and even with dimmed voltages (e.g. at alight function output). You can make the module quite easy between the (e.g. light-rear-function-output) connect and then have automatic your backlighting with neon or petroleum lamp simulation. This is especially for steam locomotives. You can easily add 2 modules (light front and light rear) but also in wagons. The module can be installed perfectly and then the lamps can be calles „neon tubes” operate. The module is also for buildings can be used.

Another special feature: You can even automatically with the brightness!
Close the enclosed brightness sensor and configure the switching threshold.
The module now switches on the light.

Technical data

Power supply: 5-26V DC/DCC/PWM 3-18V AC
Current: 5mA (with out functions)
Maximum function current: 0.8 Amps.
Temperature range: -20 up to 85°C
Dimensions LBH (cm): 1.71.20.35

NOTE: In case you intend to utilize this device below freezing temperatures, make sure it was stored in a heated environment before operation to prevent the generation of condensed water. During operation is sufficient to prevent condensed water.

Warranty, Service, Support

Micron-dynamics warrants this product against defects in materials and workmanship for one year from the original date of purchase. Other countries might have different legal warranty situations. Normal wear and tear, consumer modifications as well as improper use or installation are not covered. Peripheral component damage is not covered by this warranty. Valid warrants claims will be serviced without charge within the warranty period. For warranty service please return the product to the manufacturer. Return shipping charges are not covered by micron-dynamics. Please include your proof of purchase with the returned good. Please check our website for up to date brochures, product information, documentation and software updates. Software updates you can do with our updater or you can send us the product, we update for you free.