szfzmz ZWT005 Sprinkler Timer Water Timer for Garden Hose User Manual

szfzmz ZWT005 Sprinkler Timer Water Timer for Garden Hose

IMPORTANT! PLEASE READ!

NOTE:

• For outdoor use only
• Clean the filter regularly and replace if it is worn in order to extend the working life of the timer
• In winter, please remove batteries, drain and store it indoors away from freezing
• Do not install the timer with tools. Hand tighten ONLY. The use of tools may damage the timer
• Do not subject the product to extreme force and shock
• To prevent leakage, make sure that the water timer is tightly attached to the faucet and hose, add a rubber washer, and thread seal tape if necessary
• For any problems during use, please get support as follows: [email protected].

PRODUCT OVERSEW

At A GLANCE

SPECIFICATION

INSTALLATION

INSTALLING THE BATTERY

Note:

• Firmly restore the battery tray to ensure water resistance.
• Removed old batteries at the end of the watering season and disposed of properly.
• Used-up or dead batteries must be removed from the timer and disposed of properly.
• Do not dispose of batteries in the fire. Batteries may explode or leak. Replace batteries when the low battery indicator appears on display.

INSTALLING THE TIMER

1. Attach the timer to an outdoor hose faucet.
2. Please turn on the tap after programming the timer.

Note:

• When programming the timer, please turn off the tap to avoid getting wet.
• Do not use tools on the timer. Hand tightens only.
• Used up or dead b-ries must be removed from the timer and disposed of property.
• Keep away from freezing. The timer should be removed to avoid freezing damage.
• To prolong the life of the timer, keep the filter clean and in place when using the timer.

STEP 1: SET CLOCK

1. Tum the dial to SET CLOCK.
2. Press the “ ” to setthecurrenthourand mintues. Press” ” or turn the dial to save changes.

TIPS:

• Hold the “ ” or” ” button can increase the time quickly.
• At the end of the setting, please turn the dial to save changes. If you press” ” at the end, it will go back to the first setting.

STEP 2: SET START TIME

1. Tum dials to START TIME.
2. Press the “ ” tosetthe current hou rand mintues. Press” ” or turn the dial to save changes.

TIPS:

• Hold the “ ” or” ” button can increase the time quickly.
• At the end of the setting, please turn the dial to save changes. If you press” ” at the end, it will go back to the first setting.

STEP 3: SET HOW LONG

1. Tum dials to HOW LONG.
2. Press the” “to select the watering duration and press the” ” button or tum dial to save changes.

TIPS:

• Hold the “ ” or “ ” button can increase the time quickly.
• At the end of the setting, please turn the dial to save changes. If you press” ” at the end, it will go back to the first setting.

STEP 4: SET HOW OFTEN

1. Tum dials to HOW OFTEN.
2. Press the” ” to select the watering duration and press the” ” button or tum dial to save changes.

TIPS:

• Hold the “ ” or” ” button can increase the time quickly.
• At the end of the setting, please turn the dial to save changes. If you press” ” at the end, it will go back to the first setting.

STEP 5: SET AUTO

1. Tum dials AUTO to allow your timer to water as you set the program before.
2. It will display the current day and time and follow the next watering plan.

STEP 6: SET OFF

1. Tum dials to OFF, and the screen shows OFF and the battery level. All programs are saved and the timer stops working.

ADDITIONAL FEATURES

MANUAL WATERING
Please make sure the timer is in Auto Run state.

1. Press the” “and press” ” to select the watering duration from 1 min to 23 hours 59 mins.
2. Press the” ” button or no operation 10s, it will start to water. When you press the” ” button again, the manual watering task ends even if it is watering and the timer will switch back to Auto mode.

MANUAL WATERING

Please make sure the timer is in Auto Run state.

1. Hold and press the” ” button Ss until the appears on the screen.
2. Press the” ” button to set the duration of the delay from 1 to 7 days.
3. Press the” ” button to save changes.

CHILDREN LOCK

• Please make sure the timer is in Auto Run state.
• Hold and press the” ” button Ss until the “ ” appears on the screen.
• If you want to cancel the “ “, press” ” button Ss again

FAQs

• Q1: The LCD screen does not display anything when the batteries are installed.
  A 1: Two batteries loaded are new 1.5V AA alkaline batteries, make sure the batteries are properly placed in the battery box.

• Q2: Waterdoes not come on at presettime.
  A2: Check if:

  • The clock should be set to the correct time.
  • The start time is set to desired the time.
  • Rain Delay is on.
  • OFF mode is on.
  • The batteries are low.
  • The faucet is turned off.

• Q3: The hose tap connection/outlet leaks.
  A 3: Check if:

  • The 0-ring is connected correctly to the hose tap.
  • The connection outlet or water pipe is broken.
  • The faucet and water pipe have a different thread.
  • If necessary, please use an appropriate adapter or PTFE tape.

E-MAIL: [email protected].

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>