Acuity Brands Open Office Enabled nLight User Guide
- June 4, 2024
- Acuity Brands
Table of Contents
Acuity Brands Open Office Enabled nLight
CATTLE 24 2022 DESIGN GUIDE
OPEN OFFICE WITH nLIGHT ENABLED FIXTURES
SEQUENCE OF OPERATION
LIGHTS
- – ALL LIGHTS ARE DIMMABLE
- FIXTURES ARE CONTROLLED BASED ON POWER
- PACK LINE VOLTAGE AND 0-10V WIRING
- -MAXIMUM LEVEL CAN BE TASK TUNED TO ANY
- PERCENTAGE VIA PROGRAMMING
OCCUPANCY
- -PARTIAL-ON OCCUPANCY SENSORS
- AUTOMATICALLY ACTIVATE BETWEEN 50-70% OF CONTROLLED LIGHTING POWER OR FIXTURES
- MUST BE TURNED ON MANUALLY
- – PLUG LOAD TURNS ON AUTOMATICALLY
- FIXTURES AND PLUG LOAD AUTOMATICALLY
- TURN OFF WHEN ROOM BECOMES VACAN
DAYLIGHT
- -NOT REQUIRED IF ROOM HAS 24 FT2. OF
- GLAZING OR LIGHTING LOAD 120W IN THE
- SKYLIT AND THE SIDELIT DAYLIT ZONE
- SMOOTH cONTINUOUS DIMMING
- – DAYLIGHT ZONES DEFINED BY RELAY PACKS
MANUAL
- ON/OFF&RAISELOWER CONTROL OF LIGHTS
ADDITIONAL OPTIONS:
- -ROOM CAN BE CONNECTED TO NLIGHT
- BACKBONE TO ENABLE NETWORK CONTROL
- TIME SCHEDULES AND AUTOMATED DEMAND
- RESPONSE (OPENADR 2.0A)
- HVAC CONTROL IS AVAILABLE THROUGH
- THE SYSTEM-WIDE BACNET® INTERFACE OPTION ON
- THE ECLYPSE® CONTROLLER
- WIRELESS FIXTURE EMBEDDED CONTROL AND
- CCUPANCY/DAYLIGHTING SENSOR OPTIONS
- AVAILABLE. PLEASE SEE THE FIXTURE
- SPECIFICATION SHEET
SUPPORTS THE FOLLOWING REQUIREMENTS
- FULL AUTO-OFF VIA OCCUPANCY SENSOR (SECTION 130.1c)
- AREA CONTROL (SECTION 130.1a)
- PLUG-LOAD CONTROL (SECTION 130.5d)
- MULTI-LEVEL/ DIMMING CONTROL (SECTION 130.1b)
- AUTOMATIC DEMAND RESPONSE (ADR) READY (SECTION 130.1e)
- LESS THAN 120W PRIMARY DAYLIGHT ZONE DO NOT REQUIRE DAYLIGHT HARVESTING (SECTION 130.1d)
Note : Contact your Local lighting agent for more information on nLight- enabled fixtures
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>