PHILIPS AZB500 CD Sound Machine Instruction Manual

June 5, 2024
Philips

PHILIPS AZB500 CD Sound Machine

PHILIPS AZB500 CD Sound Machine-
PROD

WHAT IS INBOX

PHILIPS AZB500 CD Sound Machine-FIG1

Before using your product,read all accompanying safety information.

CHARGING

PHILIPS AZB500 CD Sound Machine-FIG2

6X1.5V R14/UM2/C CELL
To play with the device, you can use either alkaline battery (R14) or AC power.

POWER

VOLUME

DBB

AUDIO MODE

PHILIPS AZB500 CD Sound Machine-FIG6

CAUTION

DAB

PHILIPS AZB500 CD Sound Machine-FIG8

For first time use

Use DAB menus

  1. In DAB mode, press MENU to access the DAB menus.
  2. Press to toggle through the menus.
  3. Press OK to enter the menu.PHILIPS AZB500 CD Sound Machine-FIG9

INTERNET

FM RADIO

Tune to a radio stationPHILIPS AZB500 CD Sound Machine-
FIG11

Program FM radio stations automatically Press and hold PROG for 2 seconds to activate automatic programming. All available radio stations are stored automatically,then the first stored radio station is broadcast.PHILIPS
AZB500 CD Sound Machine-FIG12

Specifications

AmplifierPHILIPS AZB500 CD Sound Machine-FIG13 PHILIPS
AZB500 CD Sound Machine-FIG14

CD

PHILIPS AZB500 CD Sound Machine-FIG16

PROG

PHILIPS AZB500 CD Sound Machine-FIG17

Program tracks

  1. Press to stop playback.
  2. Press PROG to activate the program mode.
  3. Press to select a track,then press PROG to confirm.
  4. Repeat steps 3 to program more tracks.
  5. Press to play the programmed tracks.
    • To erase the program,press twice

Note:

  • In CD mode,the CD sound machine switches to standby mode automatically if there is no audio signal detected for over 15 minutes.
  • Press to wake up the CD sound machine from standby mode

Important

Safety

  • Read these instructions.

  • Follow all instructions.

  • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

  • Do not install near any heat sources such as radiators, heat registers, stoves,or other apparatus(including amplifiers)that produce heat.

  • Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles,and the point where they exit from the unit.

  • Only use attachments/accessories specified by the manufacturer.

  • Unplug this unit during lightning storms or when unused for long periods of time.

  • The recording is permissible insofar as copyright or other rights of third parties are not infringed upon.

  • Refer all servicing to qualified service personnel. Servicing is required when the unit has been damaged in any way, such as power-supply cord or plug is damaged,liquid has been spilled or objects have fallen into the apparatus, the unit has been exposed to rain or moisture, does not operate normally,or
    has been dropped.

  • Battery usage CAUTION – To prevent battery leakage which may result in bodily injury, property damage,or damage to the unit:

    • Install all batteries correctly,+ and – as marked on the unit.
    • Do not mix batteries(old and new or carbon and alkaline,etc.).
    • Remove batteries when the unit is not used for a long time.
  • Batteries(battery pack or batteries installed)shall not be exposed to excessive heat such as sunshine,fire or the like.

  • CAUTION:Danger of explosion if battery is incorrectly replaced.Replace only with the same or equivalent type.

  • The unit shall not be exposed to dripping or splashing.

  • Do not place any sources of danger on the unit(e.g.liquid filed objects,lighted candles).

  • Where the MAINS plug or an appliance coupler is used as the disconnect device,the disconnect device shall remain readily operable.

Warning

  • Never remove the casing of this apparatus.
  • Never place this apparatus on other electrical equipment.
  • Never look into the laser beam inside this apparatus.

Caution

  • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Notice
Any changes or modifications made to this device that are not expressly approved by MMD Hong Kong Holding Limited may void the user’s authority to operate the product.Hereby, TP Vision Europe B.V. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on
www.philips.com/support.
Disposal of your old product
Your product is designed and manufactured with high-quality materials and components, which can be recycled and reused. This symbol on a product means that the product is covered by European Directive 20212/19/EU.Inform yourself about the local separate collection system for electrical and electronic products. Follow local rules and never dispose of the product with normal household waste. Correct disposal of old products helps prevent negative consequences for the environment and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to nake the packaging easy to separate into three materials: cardboard(box), paper pulp(buffer)and polyethylene(bags, protective foam sheet.) Your system consists of materials that can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials,exhausted batteries and old equipment.
This apparatus includes these labels:

Class || equipment symbol
This symbol indicates that the apparatus has a double insulation system. The making of unauthorized copies of copy-protected material, including computer programs,files, broadcasts and sound recordings, files, broadcasts, and sound recordings, may be an infringement of copyrights and constitute a criminal offense. This equipment should not be used for such purposes.

Note

  • The type plate is located on the bottom of the apparatus.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals