Treevol Furniture WHFP047 Bookcase Benzoni Multi Tier Storage Shelves White Finish Installation Guide
- September 12, 2024
- Treevol Furniture
Table of Contents
Treevol Furniture WHFP047 Bookcase Benzoni Multi-Tier Storage Shelves
White Finish
ATTENTION!
On the next pages are the content of the pieces and the furniture. hardware
Make sure the number of hardware and parts in the ox is correct and b
everything is in good condition. When the furniture is assembled you will not
be able to make any replacement
Key Recommendations
- Assemble the cabinet between two people.
- Assemble the cabinet on a flat smooth surface, preferably on a covered floor or the box carton.
- It is recommended to use an electric screwdriver to facilitate assembly
Required Tools
Basic Hardware
Apply these instructions every time you’re using one of this connector during the assembly.
Wood Dowels
- Put in the dowel inside the indicated hole and softly hit it until it’s fully inside.
- Verify that the dowel is NOT inserted into the perforation of the minifix cam.
Minifix Cam & Spreading Bolt
- The Minifix cam has a little arrow on its upper surface you should insert these scams with the little arrow pointing toward the drilling on the panel’s edge.
- The spreading bolt should be put with the black plastic part facing down. edge.
- After joining two panels together you should turn the cams 180° with a phillips head screwdriver to adjust and secure the joint.
Hardware
Max Suggested Loads
- Weight in Lb
Assembly Parts
Warning: T furniture must be anchored to the his! wall for proper operation heck step 14)
Locate the of the center at this distance
Make sure that the perforation of the rear panel does not remain between the
union of the pieces K so that they do not separate.
Fix your cabinet to the wall
- On the wall, measure and mark the points shown below.
- Drill on the markings with a 5/16″ drill bit.
- Insert the wall anchors inside the drillings.
- Place the cabinet and secure it with the screws.
Warning: T furniture must be anchored to the his! Wall for proper operation.
After you finish the adjustment of the cams and screws, cover them with the cover caps. After you finish assembling the cabinet, take off the adhesive letters.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>